2. BLOTZ
  3. B28-ME-003

BLOTZ B28-ME-003 Assembly Instructions

  • I have analyzed the provided instructions for assembling the BLOTZ B28-ME-003 model, a 28mm Middle Eastern Building. The document outlines the steps for assembling the model, including gluing the walls, base, roof supports and door. I understand the process and am ready to answer your questions about the assembly and the model itself.
  • What kind of glue is required?
    What tool is required to remove sections from the sprue?
    Can sandpaper be used when assembling a model?
28mm Middle Eastern Building #3
B28-ME-003
Please read these instructions fully before starting construction.
PVA or equivalent glue will be required to stick sections together.
Sand paper can be used to gently clean any joints.
A sharp modelling knife will be required to remove sections from the sprue. Please use knives with due care and
remember to cut away from yourself at all times.
During the construction of this model, you may find it convenient to use pegs / elastic bands to hold pieces in place while
you allow glue to dry.
Remove the side and front walls from the sprue.
Glue them together to form an “H” shape as shown
above.
Glue this to the base.
Take the rear and arch walls…
..and glue them into position.
Take the roof supports.
Glue them into place so that they stick out
through the walls (see pic)
Glue the door into position.
Place (do not glue) the roof pieces in position
them glue the trapdoors to them.
Remove the archway pieces from the sprue..
Glue a set to the front and rear of the archway as
shown above.
The completed building.
/