2. BLOTZ
  3. B20-ME-105

BLOTZ B20-ME-105, B20_ME_105, BH0-ME-105 Assembly Instructions

  • Hello! I'm a chat assistant, and I've analyzed the instructions for the BLOTZ Desert Fort B20-ME-105 model. This document provides a guide on assembling the short wall arch model, including details on required adhesives and tools, and step-by-step instructions for building this model. I'm ready to answer any specific questions about the construction process or the components involved.
  • What kind of glue is recommended?
    What tool is needed to remove parts from sprue?
    Can sand paper be used?
20mm Desert Fort – Short Wall - Arch
B20-ME-105
Please read these instructions fully before starting construction.
PVA or equivalent glue will be required to stick sections together.
Sand paper can be used to gently clean any joints.
A sharp modelling knife will be required to remove sections from the sprue. Please use knives with due care and remember
to cut away from yourself at all times.
During the construction of this model, you may find it convenient to use pegs / elastic bands to hold pieces in place while
you allow glue to dry.
Take the arch and the two internal walls from the
sprue.
Glue them together as shown above.
Remove the “roof” and connector pieces from the
sprue.
Turn the “roof” upside down and attach the other
pieces to it as shown.
Add the front wall.
Attach the base, slotting each lug into the
associated hole.
The finished model.
/