BLOTZ B28-ME-007 Assembly Instructions

  • Hello! I have reviewed the instructions for assembling the BLOTZ Building B28-ME-007 model. This document provides a clear, step-by-step guide for constructing your model, including recommendations for glue and tools. I’m ready to answer any questions you might have about the assembly process or the provided instructions.
  • What type of glue is recommended?
    What tool is required to remove sections from the sprue?
    What can be used to hold pieces in place while glue dries?
28mm Middle Eastern Building #7
B28-ME-007
Please read these instructions fully before starting construction.
PVA or equivalent glue will be required to stick sections together.
Sand paper can be used to gently clean any joints.
A sharp modelling knife will be required to remove sections from the sprue. Please use knives with due care and
remember to cut away from yourself at all times.
During the construction of this model, you may find it convenient to use pegs / elastic bands to hold pieces in place while
you allow glue to dry.
Remove the four main walls and base from the
sprue.
Glue them together as shown to form an open
topped box.
Take the four sections of steps and two
surrounding walls from the sprue.
Glue the short wall into position.
Insert the four sections of steps.
then glue the covering wall into place.
Take the roof supports as shown above.
Glue them into place so that they extend through the
wall (see pic).
Glue the door into position.
Place (do not glue) the roof into position, then glue
the trapdoor to it.
The completed building.
/