BLOTZ B15-ME-100 Assembly Instructions

  • I've reviewed the instructions for the Desert Fort Long Wall model. The document outlines the necessary steps to assemble the model from its components, including the use of glue and tools. I am ready to help you with any questions you have about the model or the assembly process.
  • What type of glue is recommended?
    What additional tools are required?
    What should I be careful of when using a knife?
15mm Desert Fort Long Wall
B15-ME-100
Please read these instructions fully before starting construction.
PVA or equivalent glue will be required to stick sections together.
Sand paper can be used to gently clean any joints.
A sharp modelling knife will be required to remove sections from the sprue. Please use knives with due care and remember
to cut away from yourself at all times.
During the construction of this model, you may find it convenient to use pegs / elastic bands to hold pieces in place while
you allow glue to dry.
Take the rear wall and two internal supports from
the sprue.
Glue them together as shown.
Remove these pieces from the sprue.
(Note the walkway piece is upside down at this
point)
Add them to the model.
Note the longer side connecter pieces should be
on the right (see pic).
[Optional] Glue the door behind the doorway.
Add the front wall.
Add the base, gently slotting each lug into the
associated hole.
The finished model.
/