2. BLOTZ
  3. B28-WW2-102

BLOTZ B28-WW2-102 Assembly Instructions

  • I have analyzed the instructions for the 28mm WWII B28-WW2-102 Hospital Hut model. The document provides guidelines for assembling the model, including how to attach the walls, windowsills, roof and roof supports. I'm ready to answer any questions you may have about the construction process or the model itself.
  • What type of glue is recommended?
    Is any special tools required?
    What is the purpose of the sandpaper?
28mm WWII Hospital Hut
B28-WW2-102
Please read these instructions fully before starting construction.
PVA or equivalent glue will be required to stick sections together.
Sand paper can be used to gently clean any joints.
A sharp modelling knife will be required to remove sections from the sprue. Please use knives with due care and remember
to cut away from yourself at all times.
During the construction of this model, you may find it convenient to use pegs / elastic bands to hold pieces in place while
you allow glue to dry.
A full-colour copy of these instructions can be found on our website: www.blotz.co.uk
Remove the four walls and all the windowsill
pieces from the sprue.
Glue the windowsills into position so that they are
flush with the back of the wall and extend outwards
slightly at the front (as shown).
Glue the four walls into position around the floor,
aligning the lugs on the floor with the holes in the
base of each wall.
Glue the roof supports to the underside of one
piece of the roof. Allow to dry, then glue the other
half of the roof into position.
Sit the roof on top of the building.
/