2. BLOTZ
  3. B10-ME-207

BLOTZ B10-ME-207 Assembly Instructions

  • Hello! I'm here to help you with the instructions for assembling the BLOTZ City Wall B10-ME-207 model. I've reviewed the document, which contains instructions for a 10mm ancient city wall with a gate. It includes steps for preparing the parts, gluing them together, and assembling the archway, base, walkway, and front wall. Feel free to ask me any questions you have about the assembly process.
  • What glue is recommended for assembly?
    What tool is needed to remove sections from the sprue?
    Is any type of holding method recommended while gluing?
10mm Ancient City Wall – Long Wall with Gate
B10-ME-207
Please read these instructions fully before starting construction.
PVA or equivalent glue will be required to stick sections together.
Sand paper can be used to gently clean any joints.
A sharp modelling knife will be required to remove sections from the sprue. Please use knives with due care and
remember to cut away from yourself at all times.
During the construction of this model, you may find it convenient to use pegs / elastic bands to hold pieces in place
while you allow glue to dry.
Take the pieces shown above from the sprue.
Glue them together as shown.
Take these pieces.
Glue them together to form an archway.
Using these pieces…
Glue them together to form this.
Add the base.
Take the archway and gates….
And slot them into position.
Attach the walkway.
The front wall pieces and strip.
Add them to the model.
/