2. BLOTZ
  3. B10-ME-003

BLOTZ B10-ME-003, B10_ME_003 Assembly Instructions

  • Hello! I've reviewed the instruction manual for the Building Model Middle East B10-ME-003. This guide provides detailed steps on how to assemble the 10mm scale building model. It includes information on using PVA glue, a sharp modeling knife, and sandpaper for assembly. I am ready to assist you with any questions you may have about the assembly process or the provided instructions.
  • What type of glue is required?
    What tool is needed to remove sections from the sprue?
    Can I use sandpaper?
10mm Middle East #3
B10-ME-003
Please read these instructions fully before starting construction.
PVA or equivalent glue will be required to stick sections together.
Sand paper can be used to gently clean any joints.
A sharp modelling knife will be required to remove sections from the sprue. Please use knives with due care and
remember to cut away from yourself at all times.
During the construction of this model, you may find it convenient to use pegs / elastic bands to hold pieces in place
while you allow glue to dry.
Remove the front and rear walls of the building
plus the roof from the sprue.
Glue the roof to the wall as shown – note the position
of the hatch (top right in pic).
Take the side walls.
Glue these to the building as shown.
Add the front compound wall.
Then glue the building to the base.
Add the outer archway.
The completed building.
/