Elevance® Standard Delivery System

Midmark Elevance® Standard Delivery System, Elevance® Dental Chair, European Assistant's Unit, Procenter Systems Installation guide

  • Hello! I am an AI chatbot trained to assist you with the Midmark Elevance® Standard Delivery System Installation guide. I’ve already reviewed the document and can help you find the information you need or explain it in simple terms. Just ask your questions, and providing more details will help me assist you more effectively!
  • Who should install the electrical and plumbing supply connectors inside the J-Box?
    What is the required air pressure range?
    What type of receptacle should be installed in the J-Box for 115VAC power?
    What are the water pressure requirements for the J-Box?
    What should be used to supply filtered air to the J-Box?
    What is the recommended water supply hardness level?
English - 1
© 2011 Midmark Corp. | 60 Vista Drive Versailles, OH 45380 USA | 1-800-643-6275 | 1-937-526-3662 |
003-2031-99 Rev. DA1 (12/10/19)
Language of origin: English
Electrical Supply Requirements
Have an electrician install a 1/2 in. (13 mm) conduit box with quad or equal
receptacle. Top of box must be no higher than 4-1/2 in. (114 mm) above
finished surface of floor.
Water Supply Requirements (optional)
Use 1/2 in. (13 mm) pipe (supplied by contractor) protruding 2 in. (51 mm)
above finished surface of floor. Manual shut-off valve is to be installed by a
plumber.
Water pressure must be 30-50 (max.) PSI at the shut-off valve. Flush water
plumbing clean before making final connections to dental equipment.
Recommended water supply hardness level <60 ppm of calcium carbonate.
Elevance™ J-Box Installation Guide
Air Supply Requirements
Use 1/2 in. (13 mm) pipe (supplied by contractor) protruding 2 in. (51 mm) from
finished surface of floor. Manual shut-off valve is to be installed by a plumber.
Air pressure must be 70-100 (max.) PSI at the shut-off valve. Flush air
plumbing clean before making final connections to dental equipment.
Air supply to be filtered, dry and oil-free per NFPA 99 requirements or equivalent
local codes.
Drain Requirements (optional)
Not less than 1-1/2 in. (38 mm) I.D. pipe from downpipe to trap, decreasing to
3/4 in. (19 mm) pipe from trap to connection box. Terminate with
3/4 in. (19 mm) NPT pipe protruding 1 in. (26 mm) above finished surface of
floor. Install adapter for 5/8 in. (16 mm) drain tubing. Place trap in line and vent
to conform with local codes. [All hardware supplied by contractor].
Vacuum Requirements (optional)
Plumbing to J-Box box should be specified by central vacuum supplier and
terminated in J-Box with 3/4 in. (19 mm) O.D. tube protruding 1 in. (26 mm)
above finished surface of floor.
Equipment Alert
When installing 115~ (VAC) receptacle in the J-Box, position it so that all
the other components needed in the box will also fit.
Grounding reliability can only be achieved if this equipment is connected to an
equivalent receptacle marked Hospital Grade (NEMA 5-15R, HOSPITAL GRADE).
Attention!
The electrical and plumbing supply connectors inside the J-Box (Junction Box) must be installed by an electrician and plumber in compliance with local building codes.
All required hardware is to be supplied by contractor.
J-Box must be installed within reach of the chair umbilical [4 or 8 foot (1.2 or 2.4 m)].
Style G
midmark.com
English - 2
© 2011 Midmark Corp. | 60 Vista Drive Versailles, OH 45380 USA | 1-800-643-6275 | 1-937-526-3662 |
40
6
0
80
100
20
0
1
2
3
5
6
7
4
0
Note
Loose tubing is provided for optional equipment and may not be required for your installation. Reference the
tubing diagram in the Installation Folder for proper connections.
Step 1: Place J-box over the utility
connections. Brackets are
present to screw J-Box to the
floor if desired.
Step 2: Use compression fittings to
connect air and water regulators
to the facility utilities.
Step 3: Remove umbilical clamp and position
the umbilical in the opening as shown.
Replace umbilical clamp to secure.
Step 4: Connect the water, air and vacuum
lines for the components in this
installation.
Step 5: After testing the delivery handpieces
to ensure all connections, place the
lid on the J-Box.
Installing the J-Box
Water
Air
Connector Retainer
Tubing
midmark.com
English - 3
© 2011 Midmark Corp. | 60 Vista Drive Versailles, OH 45380 USA | 1-800-643-6275 | 1-937-526-3662 |
J-Box Dimensions and Facilities Connections
6.50 in
(16.5 cm)
11.88 in
(30.2 cm)
17.82 in
(45.3 cm)
Power
Supply
Water
Air
Vacuum
Drain
Electrical
Umbilical
4.750 in
(12.07 cm)
Dimensions are from
oor to top of cover
midmark.com
English - 4
© 2011 Midmark Corp. | 60 Vista Drive Versailles, OH 45380 USA | 1-800-643-6275 | 1-937-526-3662 |
midmark.com
Deutsch - 3
© 2011 Midmark Corp. | 60 Vista Drive Versailles, OH 45380 USA | 1-800-643-6275 | 1-937-526-3662 |
Abmessungen Verteilerkasten und Einrichtungsanschlüsse
30,18 cm
(11,88 in)
45,26 cm
(17,82 in)
Stromversorgung
Wasser
Luft
Vakuum
Strom
Ablass
Versorgungskabel
Abmessungen von
Boden bis Oberkante
Abdeckung
16,5 cm
(6,50 in)
12,07 cm
(4,75 in)
midmark.com
Deutsch - 4
© 2011 Midmark Corp. | 60 Vista Drive Versailles, OH 45380 USA | 1-800-643-6275 | 1-937-526-3662 |
midmark.com
Français - 4
© 2011 Midmark Corp. | 60 Vista Drive Versailles, OH 45380 USA | 1-800-643-6275 | 1-937-526-3662 |
midmark.com
Español - 3
© 2011 Midmark Corp. | 60 Vista Drive Versailles, OH 45380 USA | 1-800-643-6275 | 1-937-526-3662 |
Dimensiones de la caja de conexiones y conexiones del centro
30,2 cm
(11,88 pulgadas)
45,3 cm
(17,82 pulgadas)
Las dimensiones son desde el suelo
hasta la parte superior de la cubierta
Fuente de
alimentación
Agua
Aire
Vacío
Drenaje
Electricidad
Umbilical
16,5 cm
(6,50 in)
12,07 cm
(4,75 in)
midmark.com
Español - 4
© 2011 Midmark Corp. | 60 Vista Drive Versailles, OH 45380 USA | 1-800-643-6275 | 1-937-526-3662 |
midmark.com
Italiano - 4
© 2011 Midmark Corp. | 60 Vista Drive Versailles, OH 45380 USA | 1-800-643-6275 | 1-937-526-3662 |
midmark.com
/