Midmark Fixed Height Tables Installation guide

English-1

Style A

midmark.com

003-2402-00 Rev. A (8/23/2011)

Wet or Dry Treatment Table Installation

Casework (Recessed Mount)

Note

Midmark recommends to use 2 installers for this procedure.

Installer may bolt table to cabinet.

Wet Table Dimensions

Attention

Midmark recommends using a licenced

professional to install required plumbing.

Dry Table Dimensions

Applies to Models:

8003 (all)

8007 (all)

Special Tools:

none

VA1517-1i

VA1402i

Step 1: Install brackets.

English-2

Style A

midmark.com

VA1701i

Recessed Installation

Step 4: Use dimensions shown to mark top and bottom

hole locations on the back panel of table.

Drill 7/32” holes on marked locations.

Measure, Mark, Drill Hole Locations

7/32” Drill

Step 6: Move table into mounting position.

Install table to brackets through door opening.

Note: Install table bracket to cabinet bracket on door/drawer side.

Install through drilled holes on back panel to cabinet bracket.

Step 5: Verify plumbing connections will

reach proper location before

performing Step 6.

English-3

Style A

midmark.com

1 1/2" (max.)

(3.8 cm)

LOWER

TABLE

RAISE

Step 4: To install faucet with or without

sprayer follow the manufacturer’s

instructions.

Step 5: Install drain, tail pipe and hair trap.

Note: The debris trap is not intended to replace a P-trap. The

debris trap is a plumbing device that has a removable strainer

intended for installation between the tub drain and before the

standard P-trap. Midmark does not supply the P-trap.

Drain

Plumbing Installation

P-Trap

NOT Supplied

To level table (if needed)...

Step 2: Pull drawer up and out to

remove from slides.

To level table (if needed)...

Step 1: Pull drawer out then carefully pull

outside of drawer out to release

drawer slide tabs from drawer.

To level table (if needed)...

Step 3: Level table

and re-install

drawer (s).

Midmark Fixed Height Tables Installation guide

Midmark Fixed Height Tables Installation guide

Related papers