Focal Point Seem 1 Indirect FSM1IW Installation guide

Type
Installation guide
IS0733 REV. C ©2022 Focal Point, LLC | 4141 S. Pulaski Rd., Chicago, IL 60632 | www.focalpointlights.com/reference 1 of 3
Seem 1 Indirect
Wall Mount | FSM1IW
Luminaires must be installed by a qualied
electrician (check with local and national
codes for proper installation).
To prevent electrical shock, disconnect
electrical supply before installation or
servicing.
Contractor is responsible for adequately
reinforcing walls and/or ceilings to support
xture weight.
Focal Point, LLC accepts no responsibility
for inadequately reinforced walls and/or
ceilings.
The information contained in this drawing
is the sole property of Focal Point, LLC.
Any reproduction in part or whole without
the written permission of Focal Point, LLC
is prohibited.
BEFORE YOU BEGIN COMPONENT KEY
FOCAL POINT SHIPPED INSTALLED
U - Individual
S - Start of Run
I - Intermediate
Non-Feed
E - End of Run
I - Intermediate
Feed
18.08"
1.24"
2.50"
Ø 1.00"
Dimensions shown are from the room side observing the wall.
Luminaire outline
1
Feed location is the same for all housing lengths
Mounting Screw
(700322)
(2 per luminaire)
Joiner Bracket
(A43542-01)
SHIPPED IN HARDWARE BAG
Mounting Rail
INDIVIDUAL UNIT INSTALLATION FOLLOW STEPS 1-6, 11 & 12
Congurations are run specic,
please consult factory drawings
before beginning installation.
Joiner Screw
(72118)
POWER OFF
POWER ON
ATTENTION
SEE ADDITIONAL
INSTRUCTIONS
INSTRUCTION KEY
Use 1/2" trade size conduit
(by others) for electrical feed.
DO NOT USE J-BOX.
IS0733 REV. C ©2022 Focal Point, LLC | 4141 S. Pulaski Rd., Chicago, IL 60632 | www.focalpointlights.com/reference 2 of 3
6
211
34
11
5
Avoid all contact with LED surface,
LEDs are easily damaged!
Install remaining rails (fasteners by others).
Remove end section from last rail.
Ø 1.00"
Electrical access cutout
X2 Per housing
Fasteners by others
7
810 X2 Per housing
11
11 12
Avoid all contact with LED surface,
LEDs are easily damaged!
Avoid all contact with LED surface,
LEDs are easily damaged!
Avoid all contact with LED surface,
LEDs are easily damaged!
B
B
B
B
9
IS0733 REV. C ©2022 Focal Point, LLC | 4141 S. Pulaski Rd., Chicago, IL 60632 | www.focalpointlights.com/reference 3 of 3
DRIVER SERVICE
111
2
Avoid all contact with LED surface,
LEDs are easily damaged!
  • Page 1 1
  • Page 2 2
  • Page 3 3

Focal Point Seem 1 Indirect FSM1IW Installation guide

Type
Installation guide

Ask a question and I''ll find the answer in the document

Finding information in a document is now easier with AI