2. Focal Point
  3. Seem 1 Pop-Down Lens FSM1S-PD

Focal Point Seem 1 Pop-Down Lens FSM1S-PD, Seem 1 Direct Suspended / Surface Mount FSM1S Installation guide

  • I have analyzed the provided Installation Instructions for Seem 1 suspended luminaires. This document includes details on installation, lens configurations, and electrical requirements. I'm ready to answer your questions about the Seem 1 FSM1S and FSM1BS models, including assembly, driver service, and specifications.
  • Who should install the luminaires?
    What should be done before starting the installation?
    Which parts are shipped installed?
    What could happen if walls and/or ceilings insufficiently reinforced?
IS0679 REV. G ©2022 Focal Point, LLC | 4141 S. Pulaski Rd., Chicago, IL 60632 | www.focalpointlights.com/reference 1 of 2
Seem® 1 Suspended
FSM1S | FSM1BS
• Congurationsarerunspecic,
pleaseconsultfactorydrawings
beforebeginninginstallation.
• Luminaires must be installed by a qualied
electrician (check with local and national
codes for proper installation).
• To prevent electrical shock, disconnect
electrical supply before installation or
servicing.
• Contractor is responsible for adequately
reinforcing walls and/or ceilings to support
xture weight.
• Focal Point, LLC accepts no responsibility
for inadequately reinforced walls and/or
ceilings.
• The information contained in this drawing
is the sole property of Focal Point, LLC.
Any reproduction in part or whole without
the written permission of Focal Point, LLC
is prohibited.
POWER OFF
POWER ON
ATTENTION
SEE ADDITIONAL
INSTRUCTIONS
BEFORE YOU BEGIN COMPONENT KEY
INSTRUCTION KEY
U - Individual
S - Start of run
I - Intermediate
E - End of run
Flush Lens
Asymmetric Lens
Pop-Down Lens
( Individual housings only, up to 8')
FOCAL POINT SHIPPED INSTALLED
Joiner
(A46895-01)
Alignment Plate
(A46949-01)
Alignment Plate Screw
8-32 x 7/8"
(700366)
Joiner Screw
10-32 x 3/4"
(700365)
Product ID label
on reector
Asymmetric Lens Distribution Direction
ASYMMETRIC DISTRIBUTIONS
INDIRECT ASYMMETRIC DIRECT/INDIRECT ASYMMETRIC
Standard Application Example Standard Application Example
Wall Wall
Power Feed Power Feed
Asymmetric Optic
Distribution Direction
Asymmetric Optic
Distribution Direction
Asymmetric Lens
Distribution Direction
Asymmetric Optic
Distribution Direction Asymmetric Optic
Distribution Direction
Asymmetric Optic
Distribution Direction
Asymmetric Lens Distribution Direction
Asymmetric Lens Distribution Direction
Asymmetric Optic
Distribution Direction
IS0679 REV. G ©2022 Focal Point, LLC | 4141 S. Pulaski Rd., Chicago, IL 60632 | www.focalpointlights.com/reference 2 of 2
INDIVIDUAL INSTALLATIONS FOLLOW STEPS 1 & 2
21
4
Two cable grippers each for individual and
start, one for intermediate and end housings.
Follow Focal Point instructions for
Universal Suspension System assembly.
See IS0166
MAKE ELECTRICAL CONNECTION
WIRE NUTS
BY OTHERS
3
5
7 8
11
6
DO NOT OVERTIGHTEN.
Note: Screw head may not seat to bracket. Seat screw rmly.
DRIVER SERVICE
1 2
Avoid all contact with LED surface,
LEDs are easily damaged!
Alignment Plate
Screw (700366) Joiner Screw
(700365)
/