Candy CTS 40 SY User manual

Category
Washing machines
Type
User manual
A PROGRAMME & TEMPERATURE SELECTOR DIAL
C1 HOT/ COLD KEY
C2 LIGHT LOAD KEY
H START/STOP KEY
p CONTROL POSITION INDICATOR
WASHING MACHINE CANDY CTS 40
1/2
C1
A
pC2 H
2
5
5
5
5
2
2
2
1
50º
90º
90º
60º
40º
60º
50º
40º
40º
32
180
120
85
70
55
43
10
80
70
65
50
25
7
5
32' express
heavily soiled cotton
soiled cotton
*cottons
coloured
bleach (organic stains)
vigorous rinse
vigorous spin
mixed garments
coloured
acrylic
Woolmark certified woollens
delicate rinse
stop with water in drum
delicate spin
empty
32´
1
2
3
4
5
6
7
8
Programme table mod. CTS 40
Mains
voltage
Wash
power
rating
Spin
power
rating
Pump
motor
power
rating
Heating
element
power rating
Max.
power
input
Mains fuse
amp. rating
Water
pressure
Water
consumption
* prog.
EN 60456
Energy
consumption
* prog.
EN 60456
230 V. /
50 Hz.
175 W. 340 W. 30 W. 1950 W. 2200 W. 10 A. 0,05-0,8
Mpa
69 L. 1,35 Kw/h.
*Programme as per EN 60456
Technical data mod. CTS 40
COTTONS
MIXED /SYNTHETICS
DELICATES
400
400
400
400
400
400
400
400
400
400
400
400
400
400
I II
SPECIAL
programme programme for
aprox.
time
min.
Máx. temp.
setting
ºC
Máx.
spin
speed
Máx.
load
kg
Washing powder load
Option keys C
programme
selection
1/2
PREPARING THE WASH CYCLE
1.- Once the washing is loaded, ensure that the drum doors are properly closed.
2.- Add detergent and additives, not exceeding the maximum level indicator.
.- detergent for pre-wash I
.- detergent for wash programme II
.- bleach
.- fabric conditioner
SELECTING THE DESIRED PROGRAMMES AND OPTIONS
3.- Turn the programme selector dial (A) to the desired programme (clockwise only)
4.- Press the key or keys for any options desired (C1, C2 ).
C1 hot/ cold key
If this key is pressed the heating element is not connected, i.e. the machine washes cold.
This works in all programmes.
C2 light load key
Press this key to lower the water level for light loads, thus saving water, detergent and
electricity.
5.- Once you have selected the desired options, press the Start key (H).
To cancel an option selected, just press the key again.
To change or cancel a programme
To change or cancel a programme once the programme selected has started, proceed as
follows:
- Press (H). The programme has been cancelled, and another may be selected.
- Select the new programme.
- Press (H) again.
- The machine will then run the new programme selected.
Programme pause
To pause the wash programme so that more washing can be added, proceed as follows:
- Press (H). When the door safety lock is released (after approx. 2 minutes), open the door
and add more clothes as required.
- Close the door and press (H) again.
- The machine will continue with the programme.
Fast programme –32 minutes
The 32-minute fast programme runs through a full cycle for up to 2 kg of washing at 50 ºC.
Place detergent in the tray (compartment I), using no more than around _ of the recommended
quantity.
The 32-minute fast programme can also be used as a pre-wash programme for heavily soiled
clothes by then selecting the desired main programme.
NB
In MIXED, COLOURED, ACRYLIC & WOOL programmes the machine stops with water in the
drum at the end of the last rinse due to the easy-iron feature.
To complete the cycle by spin washing, turn the programme dial one step forward.
10-04 / 46001941 EN
To complete the cycle by merely emptying the machine, select the (empty) programme.
END OF PROGRAMME
For safety’s sake, when the programme ends set the Start/Stop key to Stop.
1 / 1

Candy CTS 40 SY User manual

Category
Washing machines
Type
User manual

Ask a question and I''ll find the answer in the document

Finding information in a document is now easier with AI

Ask the document