2. ITC
  3. 69517
69517

ITC 69517 Installation guide

  • Hello! I have reviewed the installation instructions for the ITC Pin Lights (models 69516 and 69517). This document provides details on mounting the lights with and without a bezel, wiring for 12V DC power, and the importance of correct polarity. I am ready to answer your questions about the installation process and key features.
  • What is the required hole size when installing without the bezel?
    What is the required hole size when installing with the bezel?
    What is the polarity of the wires?
    What should I do with rubber grommet if I have bezel?
3030 Corporate Grove Dr.
Hudsonville, MI 49426
Phone: 616.396.1355
itc-us.com
WITHOUT BEZEL:
- Drill a 0.375” for single color or 0.5” for RGB(W)/addressable hole in the mounting surface
- Attach wires to the power source. Red is positive and black neutral
- Slide light off the rubber grommet, install rubber into the hole, and then slide the light back into the grommet
1.
INSTALLATION CONSIDERATIONS
• To avoid a hazard to children, account for all parts and destroy all packing materials.
• Disconnect power before installing, adding, or changing any component.
• Positive (+) outputs require a fuse if the attached wire leads are not rated to handle the max current.
• The brushed nickel bezel can be used in interior applications only.
• LEDs are polarity sensitive and will not light if not attached properly.
PARTS/TOOLS NEEDED:
Pin Light Power Drill
(Not Provided)
INSTALLATION INSTRUCTIONS
Pin Courtesy Light
Part#: 69516, 69517
For warranty information please visit www.itc-us.com/warranty-return-policy
Rev C • 06/26/23
Page 1 of 1
WITH BEZEL:
- Remove the rubber grommet and throw away
- Drill a 0.4375” hole in mounting surface
- Attach wires to the power source. Red is positive and black neutral
- Slide the bezel and light into the mounting surface
ARGB Wiring
RGBW Wiring
Black (-)
Orange (-)
ARGB
Controller
Incoming
12V DC
Power
Red (+)
Black (-)
Incoming
12V DC
Power
RGBW
Controller
Red (+)
Black (-)
Red (-)
Green (-)
Blue (-)
White (-)
Black (+)
Red (+)
/