2. ITC
  3. 696T-FF-XXX
696T-FF-XXX

ITC 696T-FF-XXX User manual

  • I have reviewed the Installation Instructions for the ITC Step Light 696T-FF-XXX. The document outlines the necessary steps for proper installation, including wiring, drilling and safety guidelines. I'm ready to answer any questions you may have about the installation process or the light itself.
  • What should I do before installing the light?
    What size hole should I drill for the wires?
    What size holes should I drill for the screws?
    Is it recommended to add fuse protection?
3030 Corporate Grove Dr.
Hudsonville, MI 49426
Phone: 616.396.1355
itc-us.com
For warranty information please visit www.itc-us.com/warranty-return-policy
DOC #: 710-00219 • Rev B • 11/02/2022
1. Determine the installation location for your light and mark
the location of the holes needed. Center the wire exit hole
between two screw holes.
PARTS/TOOLS NEEDED:
Tread Step Light Drill & Drill Bit Screws (Included)
IMPORTANT SAFETY INSTRUCTIONS. READ CAREFULLY FOR YOUR PROTECTION AND SAVE ALL INSTRUCTIONS.
• Disconnect power before installing, adding or changing any component.
• To avoid a hazard to children, account for all parts and destroy all packing materials.
• It is recommended that fuse protection be added to the positive (+) input.
4. Wire the light following the wiring diagram below.
+12V
White (+)
Black (-)
Incoming
12V DC
Power
Fuse
2. Pre-drill a 1/4” hole for the wires.1 Pre-Drill 2 1/8” holes 2
3. Use the screws to attach the light housing to the desired
location.
5. Snap the bezel on the light housing.
INSTALLATION INSTRUCTIONS
Tread Step Light
Part#: 696T-FF-XXX
Page 1 of 1
12
/