FSR FL-600P-SLD-ALM-C U-Cover Installation guide

FSR 244 Bergen Boulevard, Woodland Park, NJ 07424, Phone: 973.785.4347 - Fax: 973.785.4207

43051 LIT1479

1. REMOVE AND DISCARD TEMPORARY COVER AND SCREWS.

TEMPORARY COVER

(8) FLAT HEAD SCREW

2. INSTALL CABLE INTERFACES AND CONNECTOR PLATES IF PREVIOUSLY

NOT INSTALLED. CLEAN AREA IN AND AROUND ENTIRE TOP EDGE OF

BOX AND APPLY 1/4" CONTINUOUS BEAD OF RTV SILICONE SEALANT.

CLEAN AND APPLY SEALANT

AROUND ENTIRE EDGE

CLEAN AND APPLY SEALANT

AROUND ENTIRE EDGE

COVER

(8) O-RING

(8) FLAT HEAD SCREW

3. INSTALL COVER WITH SUPPLIED O-RINGS AND FLAT HEAD SCREWS.

INSTALL FINISHED FLOORING MATERIAL.

FL-500P/600P COVER INSTALLATION INSTRUCTIONS

4. REMOVE COVER BY LIFTING AND PULLING HANDLE UPWARD AS

SHOWN (CABLE ACCESS DOOR WILL FALL INWARD IF NOT ALREADY

OPEN). COVER CAN NOW BE PLACED FLAT ON FLOOR. CONNECT

CABLES AS REQUIRED. PRIOR TO REINSTALLING COVER, SWING

CABLE ACCESS DOOR ONTO VELCRO ON UNDERSIDE OF COVER.

REVERSE COVER REMOVAL STEPS TO REINSTALL COVER AND PUSH

FIRMLY ON CORNERS TO SNAP COVER SECURELY IN PLACE.

CABLE ACCESS DOOR

HANDLE COVER

COVER SHOWN WITH CABLE

ACCESS DOOR OPEN

COVER TAB

RIM TAB

WHEN REINSTALLING COVER

BE SURE TO INSERT COVER TABS

INTO OPENING ABOVE RIM TABS

OPENING