2. FSR
  3. FL-400-SLD-ALU-C

FSR FL-400-SLD-ALU-C Installation guide

  • Hello, I'm here to help you understand the FSR FL-400 Cover Installation Instructions. I've reviewed the document detailing the steps for installing the cover, including applying sealant, using O-rings, and correctly setting up the access doors. Ask me any questions you have about the installation process.
  • What is the first step in the installation process?
    What should be applied to the top edge of the box before installing the cover?
    What hardware is needed to install the cover?
    How do you open the large door?
    What should you do with the cable access door before closing the large door?
FSR
244 Bergen Boulevard, Woodland Park, NJ 07424, Phone: 973.785.4347 - Fax: 973.785.4207
43410 LIT1811
1. REMOVE AND DISCARD TEMPORARY COVER AND SCREWS.
2. INSTALL ELECTRICAL DEVICES AND CONNECTOR PLATES IF
PREVIOUSLY NOT INSTALLED. CLEAN AREA IN AND AROUND ENTIRE
TOP EDGE OF BOX AND APPLY 1/4" CONTINUOUS BEAD OF RTV
SILICONE SEALANT.
3. INSTALL COVER WITH SUPPLIED O-RINGS AND FLAT HEAD SCREWS.
INSTALL FINISHED FLOORING MATERIAL.
FL-400 Cover Installation Instructions
(8) FLAT HEAD SCREW
TEMPORARY COVER
CLEAN AND APPLY SEALANT
AROUND ENTIRE EDGE
CLEAN AND APPLY SEALANT
AROUND ENTIRE EDGE
(8) O-RING
(8) FLAT HEAD SCREW
COVER
4. OPEN LARGE DOOR BY LIFTING AND PULLING HANDLE UPWARD AS SHOWN
(CABLE ACCESS DOOR WILL FALL INWARD IF NOT ALREADY OPEN). LARGE
DOOR CAN NOW BE ROTATED OVER TO BE FLAT ON FLOOR. CONNECT
CABLES AS REQUIRED. PRIOR TO CLOSING LARGE DOOR, SWING CABLE
ACCESS DOOR ONTO VELCRO ON UNDERSIDE OF LARGE DOOR. ROTATE
LARGE DOOR FORWARD ON IT'S HINGES, AND PUSH FIRMLY ON CORNERS
TO SNAP LARGE DOOR SECURELY IN PLACE.
CABLE ACCESS DOOR
LARGE DOOR
HANDLE
LARGE DOOR SHOWN WITH
CABLE ACCESS DOOR OPEN
/