FSR FL-200-SLD-BLK-C Installation guide

FSR
Brand
FSR
Model
FL-200-SLD-BLK-C
Type
Installation guide

This manual is also suitable for

FSR 244 Bergen Boulevard, Woodland Park, NJ 07424, Phone: 973.785.4347 - Fax: 973.785.4207
43093 LIT1559A
1. REMOVE AND DISCARD TEMPORARY COVER AND SCREWS.
(4) FLAT HEAD SCREW
TEMPORARY COVER
2. INSTALL CABLE INTERFACES AND CONNECTOR PLATES IF PREVIOUSLY
NOT INSTALLED. CLEAN AREA IN AND AROUND ENTIRE TOP EDGE OF
BOX AND APPLY 1/4" CONTINUOUS BEAD OF RTV SILICONE SEALANT.
CLEAN AND APPLY SEALANT
AROUND ENTIRE EDGE
CLEAN AND APPLY SEALANT
AROUND ENTIRE EDGE
FL-200 COVER INSTALLATION INSTRUCTIONS
3. REMOVE DOOR BY LIFTING AND PULLING HANDLE UPWARD AS
SHOWN (CABLE ACCESS DOOR WILL FALL INWARD IF NOT ALREADY
OPEN).
HANDLE
DOOR
CABLE ACCESS DOOR
4. INSTALL RIM WITH SUPPLIED FLAT HEAD SCREWS. REVERSE DOOR
REMOVAL STEPS TO REINSTALL DOOR AND PUSH FIRMLY ON HANDLE-END
CORNERS TO SNAP DOOR SECURELY IN PLACE. INSTALL FINISHED
FLOORING MATERIAL.
AFTER FINISHED FLOOR INSTALLATION, REMOVE DOOR AND CONNECT
CABLES AS REQUIRED. SWING CABLE ACCESS DOOR ONTO VELCRO ON
UNDERSIDE OF DOOR AND REINSTALL DOOR.
DOOR SHOWN WITH CABLE
ACCESS DOOR OPEN
RIM
RIM
(4) FLAT HEAD SCREW
DOOR TAB
OPENING RIM TAB
WHEN REINSTALLING DOOR BE
SURE TO INSERT DOOR TABS INTO
OPENING ABOVE RIM TABS
COVER SHIM KIT (FL-200-CSK) MAY BE
REQUIRED TO SET THE HEIGHT OF BOX
"PRE-POUR" SO THE TOP OF FINISH
COVER MATCHES TOP OF FINISHED
FLOOR.
NOTE:
  • Page 1 1
  • Page 2 2

FSR FL-200-SLD-BLK-C Installation guide

FSR
Brand
FSR
Model
FL-200-SLD-BLK-C
Type
Installation guide
This manual is also suitable for
Download PDF
report

Ask a question and I''ll find the answer in the document

Finding information in a document is now easier with AI

Related papers

Other documents