2. BLOTZ
  3. B28-RU-005

BLOTZ B28-RU-005 Assembly Instructions

  • Hello! I've reviewed the instructions for the BLOTZ Ruin B28-RU-005 model. This document outlines the assembly process, detailing the components and steps necessary to construct the miniature ruin. It covers how to prepare the parts, glue them together, and construct the model. I'm ready to answer any questions you may have about assembling this model.
  • What is required to assemble the model?
    How should the wall sections be joined?
    What should I use to hold the pieces while the glue dries?
28mm Ruins #5
B28-RU-005
Please read these instructions fully before starting construction.
PVA or equivalent glue will be required to stick sections together.
Sand paper can be used to gently clean any joints.
A sharp modelling knife will be required to remove sections from the sprue. Please use knives with due care and remember
to cut away from yourself at all times.
During the construction of this model, you may find it convenient to use pegs / elastic bands to hold pieces in place while
you allow glue to dry.
A full-colour copy of these instructions can be found on our website: www.blotz.co.uk
Ruins #5 (B28-RU-005)
Remove the two long wall sections and two base
sections from the sprue.
Glue the wall sections back to back so that the
stonework lines up.
Attach the wall to the base sections as shown above.
Remove the door frames from the sprue.
Glue a doorframe onto each side of the wall.
/