2. BLOTZ
  3. B28-RU-007

BLOTZ B28-RU-007 Assembly Instructions

  • Hello! I've read the instructions for the BLOTZ Ruin B28-RU-007 model. This document provides a step-by-step guide on assembling the ruin using PVA glue and a modeling knife. It covers various steps, including gluing wall sections, doorframes, walkways, and bannister pieces. I'm ready to answer any questions you have about the assembly process.
  • What kind of glue is required?
    What tools will be needed?
    What is the purpose of the lugs?
28mm Ruins #7
B28-RU-007
Please read these instructions fully before starting construction.
PVA or equivalent glue will be required to stick sections together.
Sand paper can be used to gently clean any joints.
A sharp modelling knife will be required to remove sections from the sprue. Please use knives with due care and remember
to cut away from yourself at all times.
During the construction of this model, you may find it convenient to use pegs / elastic bands to hold pieces in place while
you allow glue to dry.
A full-colour copy of these instructions can be found on our website: www.blotz.co.uk
Ruins #7 (B28-RU-007)
Remove the two tall wall sections from the sprue and
glue them together back to back so the edges of the
stonework line up.
Do the same with the two shorter wall sections.
You will end up with the two walls as shown above.
Note the lugs on the bottom do not line up.
Glue the doorframes into place.
Glue the walkway into place and attach three of the
supports.
Attach the other wall and fourth support.
Then glue this whole assembly to the base.
Remove the bannister pieces from the sprue.
Attach the large bannister piece first.
The attach the smaller bannister piece and the rail.
The finished ruin.
/