BLOTZ B28-RU-001 Assembly Instructions

28mm Ruined Building #1

B28-RU-100

Please read these instructions fully before starting construction.

PVA or equivalent glue will be required to stick sections together.

Sand paper can be used to gently clean any joints.

A sharp modelling knife will be required to remove sections from the sprue. Please use knives with due care and remember

to cut away from yourself at all times.

During the construction of this model, you may find it convenient to use pegs / elastic bands to hold pieces in place while

you allow glue to dry.

A full-colour copy of these instructions can be found on our website: www.blotz.co.uk

First remove the two inside walls and the floor

section from the sprue.

Apply a little glue to the straight edges of the floor,

and to the lugs on the walls. Glue them together as

shown above. Leave to dry.

Remove the two outer walls and glue them to the

inner walls so that the edges, walls and doorway

all align.

Remove the two corner block pieces from the sprue

and glue together to form an “L” shape (etched

detail outwards).

Glue the corner block into position as shown

above.

Glue the two long stone block sections into place,

so that one end is flush with the corner blocks.

Remove the doorframe and the shutters from the

sprue.

Glue the doorframe to the outside edge of the

door. The shutters can be positioned as you wish

alongside the windows.