2. BLOTZ
  3. B28-RU-006

BLOTZ B28-RU-006 Assembly Instructions

  • I have reviewed the instructions for the BLOTZ Ruin B28-RU-006. This document outlines the steps required for assembling the ruin model, including the necessary tools such as glue, sandpaper, and a sharp knife. I am ready to answer your questions about the assembly process and any specific details regarding the model kit.
  • What kind of glue is required?
    What can be used to clean the joints?
    What kind of knife is needed?
28mm Ruins #6
B28-RU-006
Please read these instructions fully before starting construction.
PVA or equivalent glue will be required to stick sections together.
Sand paper can be used to gently clean any joints.
A sharp modelling knife will be required to remove sections from the sprue. Please use knives with due care and remember
to cut away from yourself at all times.
During the construction of this model, you may find it convenient to use pegs / elastic bands to hold pieces in place while
you allow glue to dry.
A full-colour copy of these instructions can be found on our website: www.blotz.co.uk
Ruins #6 (B28-RU-006)
Remove the two long walls and two short walls from
the sprue…
… and glue each pair together back to back so the
edges of the stonework line up.
Using the holes / lugs provided attach the short wall to
the long wall as shown above.
Glue the walls to the base.
/