2. BLOTZ
  3. B28-OW-630

BLOTZ B28-OW-630 Assembly Instructions

  • Hello! I've reviewed the instructions for the Short Roof B28-OW-630 model. This document provides guidance on assembling the model, including steps for gluing together the base, attaching framework pieces, and completing the roof structure. I'm ready to answer any questions you have about the assembly process or the materials required.
  • What type of glue is recommended?
    What tool is required to remove sections?
    Is it recommended to use any tools to hold pieces while glue dries?
28mm Short Roof #1
B28-OW-630
Please read these instructions fully before starting construction.
PVA or equivalent glue will be required to stick sections together.
Sand paper can be used to gently clean any joints.
A sharp modelling knife will be required to remove sections from the sprue. Please use knives with due care and remember
to cut away from yourself at all times.
During the construction of this model, you may find it convenient to use pegs / elastic bands to hold pieces in place while
you allow glue to dry.
Remove the pieces shown above from the sprue.
Glue them together as shown to form a square.
Turn this over and glue to the underside of the roof
(see pic).
Take the outer framework.
Glue a triangle to each side, aligning it with the back
edge of the roof.
Add the front strip.
Take the two inserts.
Glue one into each side frame.
Glue the roof strips into position.
/