2. BLOTZ
  3. B28-ME-100

BLOTZ B28-ME-100 Assembly Instructions

  • Hello! I've analyzed the instructions for the BLOTZ Desert Fort Long Wall model. This document provides a clear, step-by-step guide on how to assemble the fort, including using glue, sandpaper, and a modelling knife, with options for adding the door. I'm ready to answer any questions you might have about the construction process or the model itself.
  • What kind of glue is needed?
    What tool is needed to separate the parts?
    Can I add a door behind the doorway?
28mm Desert Fort – Long Wall
B28-ME-100
Please read these instructions fully before starting construction.
PVA or equivalent glue will be required to stick sections together.
Sand paper can be used to gently clean any joints.
A sharp modelling knife will be required to remove sections from the sprue. Please use knives with due care and remember
to cut away from yourself at all times.
During the construction of this model, you may find it convenient to use pegs / elastic bands to hold pieces in place while
you allow glue to dry.
Remove the pieces shown above from the sprue.
Add the internal supports to the back of the “door”
piece.
Glue this assembly, and the connector pieces to
the base.
[Optional] Glue the door behind the doorway.
Add the walkway section, gently slotting each lug
into the corresponding hole.
Add the front wall.
The finished model.
/