2. BLOTZ
  3. B10_ME_001

BLOTZ B10_ME_001, B10-ME-001 Assembly Instructions

  • Hello! I'm your chat assistant, and I've reviewed the instructions for the 10mm Middle East B10-ME-001 model building. I can assist you with any questions you may have about the assembly process, including part removal, glue application, and the sequence of steps to create the final model. Let me know what you'd like to know!
  • What kind of glue is required for assembly?
    What tools are needed to remove parts?
    What can be used to hold pieces while the glue dries?
10mm Middle East #1
B10-ME-001
Please read these instructions fully before starting construction.
PVA or equivalent glue will be required to stick sections together.
Sand paper can be used to gently clean any joints.
A sharp modelling knife will be required to remove sections from the sprue. Please use knives with due care and
remember to cut away from yourself at all times.
During the construction of this model, you may find it convenient to use pegs / elastic bands to hold pieces in place
while you allow glue to dry.
Remove the central wall and upper roof from the
sprue.
Glue the roof to the wall as shown – note the position
of the hatch (top right in pic).
Take the front and rear walls, plus the lower roof.
Glue these together as shown.
The two end walls.
Add them to the building.
Glue the base into position.
The completed building.
/