Danfoss SpeedUp Eco - Direct load User guide

Brand: Danfoss

Model: SpeedUp Eco - Direct load

Type: User guide

Application sheet

SpeedUp Eco

Parquet

Direct load

1 Parquet ≥ 14 mm

2 Sound insulation 2 mm

3 SpeedUp Eco heat panel + FH composite pipe 30 mm

4 Support batten (30mm)

5 Load bearing panel ≥ 15 mm

6 Wood bre insulation 20 mm

7 SpeedUp Eco perimeter insulation

8 If necessary moisture barrier

Floor nish ≥ 14 mm Parquet

Construction height ≥ 81 mm Height including oor nish

Weight 31 kg / m² Weight including oor nish

Thermal resistance R 1,26 m²K / W The minimum thermal resistance requirement of DIN EN 1264 is

fullled.

Thermal transmission coecient U 0,70 W / m²K If the architectural design species better thermal insulation, this

must be taken into account.

Design load ≤ 2,0 kN / m²

Point load (≥ 20 cm²) ≤ 1,0 kN Sum point load ≤ design load; please notice special heavy ob-

jects (aquaria etc.)

Impact subsonic noise reduction 22 dB Test value according to DIN ISO 140-8; applies to concrete slabs

thicker than 12 cm (DIN 4109: m’ > 276 kg/m²)

Application area

Residential spaces, hallways and attic spaces in residential buildings and hotel rooms.

Corresponds to categories A1, A2 and A3 of DIN 1055-3.

Requirements & special features

A level, smooth and structurally sound surface is necessary for full surface contact with

the heating elements (elevated requirements according to DIN 18202 Table 3, row 4).

Structural sealing according to DIN 18195 must be placed beneath the oor panel in

case of structures facing the ground, and otherwise on the unnished oor. The R value

must be increased if the groundwater level is less than or equal to 5 m. A U value not

exceeding 0.5 W/m²K must be maintained in existing buildings and additions with areas

up to 50 m². If necessary, protect oorboards and prefabricated parquet against mois-

ture penetration from below (vapour barrier). Observe all installation instructions and

manufacturer’s instructions.

Additional insulation

20 mm wood bre insulation 150kPa, renovation: 50 mm wood bre insulation 150 kPa,

WLG 050

Construction

According to EnEV, EN 1264, DIN 1055, 18195 and 18202

Construction number 87

Technical Data Floors/ceilings facing unheated rooms or the ground

VA.CS.K1.02

Danfoss HES

Danfoss SpeedUp Eco - Direct load User guide

Danfoss SpeedUp Eco - Direct load User guide

Danfoss SpeedUp Eco - Direct load User guide

Related papers

Other documents