Danfoss SpeedUp - Cement screed User guide

Brand: Danfoss

Model: SpeedUp - Cement screed

Type: User guide

Danfoss SpeedUp - Cement screed provides an efficient underfloor heating system for residential spaces, hallways, and attic spaces. It boasts a low construction height of 95mm, making it ideal for renovations. With a thermal resistance of 1.43 m²K/W and a U-value of 0.63 W/m²K, it ensures optimal heat distribution and energy savings. Experience comfortable warmth underfoot with Danfoss SpeedUp - Cement screed.

Application sheet

SpeedUp

Carpet / tiles / parquet / laminate / synthetics

Cement-screed

1 Carpet / tiles / parquet

2 Cement-screed (≥ CT-F4) 45 mm

3 System foil

4 SpeedUp heat panel + FH composite pipe 30 mm

5 Support batten (30mm)*

6 Additional insulation EPS 035 DEO 20 mm

7 Basic perimeter insulation

8 If necessary moisture barrier

Floor nish NA mm Carpet / tiles / parquet / laminate / synthetics

Construction height 95 mm Height excluding oor nish

Weight ~ 94 kg / m² Weight excluding oor nish

Thermal resistance R 1,43 m²K / W The minimum thermal resistance requirement of DIN EN 1264 is

fullled.

Thermal transmission coecient U 0,63 W / m²K If the architectural design species better thermal insulation, this

must be taken into account.

Design load ≤ 2,0 kN / m²

Point load (≥ 20 cm²) ≤ 1,0 kN

Impact subsonic noise reduction NA dB For impact sound requirements use additional insulation of EPS

DEO S < 2 mm.

Application area

Residential spaces, hallways and attic spaces in residential buildings and hotel rooms.

Corresponds to categories A1, A2 and A3 of DIN 1055-3.

Requirements & special features

Structural sealing according to DIN 18195 must be placed beneath the oor panel in case

of structures facing the ground, and otherwise on the unnished oor. The R value must

be increased if the groundwater level is less than or equal to 5 m. A U value not exceed-

ing 0.5 W/m²K must be maintained in existing buildings and additions with areas up to

50 m². The screed thicknesses must be adjusted in case of higher design load or point

load values. * Construction without a stabilising support batten is also possible. Observe

all installation instructions and manufacturer’s instructions.

Additional insulation

20 mm EPS 035 DEO; existing buildings: 40 mm

Construction

According to EnEV, EN 1264, DIN 1055, 18195, 18202 and 18560

Construction number 78

Technical Data Floors/ceilings facing unheated rooms or the ground

VA.CR.L1.02

Danfoss HES

Danfoss SpeedUp - Cement screed User guide

Danfoss SpeedUp - Cement screed User guide

Danfoss SpeedUp - Cement screed User guide

Related papers

Other documents