Midmark VetPro 5000 Mounted Dental Delivery System Installation guide

Brand: Midmark

Model: VetPro 5000 Mounted Dental Delivery System

Type: Installation guide

This manual is also suitable for

VetPro Solo

Midmark VetPro 5000 Mounted Dental Delivery System is a state-of-the-art dental system designed to meet the specific needs of veterinary professionals. It features a compact design which is wall, cabinet, or table mountable. The VetPro 5000 offers both solo and junction box configurations, providing flexibility in installation. The system boasts an ergonomic design, ensuring comfortable use during various dental procedures. Additionally, it includes an easy-to-use control panel, allowing for precise adjustments and efficient operation.

English-1

TP200 Rev. A

004-1080-00 Rev. A (9/13)

Pre-installation Guide for VetPro

5000 Dental System

Note

Please allow time for basic equipment training after the installation (approx 10 minuntes) The complete training is available

in-service. To schedule an in-service please contact Vet Customer Service at Midmark, 1-800-Midmark (1-800-643-6275).

Name of Clinic___________________________________Contact Name__________________________________

Address_____________________________________________________________________________________

Phone_________________________________Email:_________________________________________________

1. What method will the delivery system be mounted? (Wall, cabinet, or table)_________________________

2. Will a junction box or solo unit be utilized? __________________

Note: Outlet must be within 5 ft of the Solo unit; If a junction box is used please refer to the junction box template.

3. Is power available? ______________________

Note: Review power requirements within this pre-install guide.

4. If “NO” to Q.3 what date will the power be available? ______________

5. Will this be a dedicated line?____________Midmark strongly recommends a dedicated line.

Note: Electrician will need a template to determine exact location for the electrical wiring to be installed when using a junction

box.

6. Is there anything that might interfere with the dental system in its home position? _________________________________

Refer to minimum space requirements in this guide.

7. Is the stud material wood or metal? ________________

Note: Site must have two studs available to complete the install for wall mounted units.

Style A

midmark.com

English-2

TP200 Rev. A

Suggested Mounting Location From Procedure Table

Delivery Unit can be installed on left or right side of table or cabinet.

180° Arm Length

Standard - 28”

Short - 13 1/2”

250°

Arm Length

Standard - 45.3”

Short - 37 5/16”

Mounting Requirements

Mounting Structure Note: The mounting structure must be capable of supporting the

weight and torque listed below without deection.

Unit / Arm Assembly Maximum

Weight 50lbs (22.6 kgs)

Torque 170.8 ft. lbs. (231.5 N•M)

Note: To prevent unit from drifting, the mounting plate must deect no more than 1/16” (1.6 mm)

over a 12” (30.5) distance.

Cabinet or Wall

Note

WHIP head folded against wall measures 30.6” from center of main axis to outermost point.

Specications

Water Module

Reservoir One - 1 Liter

City Water Toggled with Reservoir

Pressurized System 30 - 50 PSI

Aseptic Non-Retracting HPC Coolant

Handpiece Flush System Manual

Recommended Pressure Settings (Junction Box)

“City” Water Regulator Valve 30 PSI

Air Regulator Valve 80 PSI

Water Bottle Regulator Valve 30 PSI

Electrical

Voltage 115 VAC

Circuit Breaker Protection 15 amps

Frequency 60 Hz

Space Requirements

Style A

midmark.com

English-3

TP200 Rev. A

Range of Motion

Style A

midmark.com

English-4

TP200 Rev. A

Junction Box

Equipment Alert

When installing 115 VAC receptacle in the junction box,

the ground must be positioned as shown on diagram/template

(in this manual) to accommodate power cord.

Electrical Requirements

• 115 VAC models only - Grounding reliability can only be achieved if this equipment is connect

to an equivalent receptacle marked Hospital Grade (NEMA 5-15R, HOSPITAL GRADE).

• 1/2” (13mm) conduit box with quad receptacle.

• Wire box per local codes and regulations.

Water Supply Requirements

• 1/2” (13 mm) pipe (supplied by contractor) protruding 2” (51 mm) above finished surface of floor.

• Manual shut off valve ( supplied by Midmark) to be installed by contractor.

• Water pressure must be 30-50 (max.) PSI at the shut-off valve. Flush water plumbing clean before

making final connections to dental equipment.

Air Supply Requirements

• 1/2” (13 mm) pipe (supplied by contractor) protruding 2” (51 mm) from

finished surface of floor.

• Manual shut off valve ( supplied by Midmark) to be installed by contractor.

• Air pressure must be 80 - 100 (max.) PSI at the shut-off valve.

• Flush air plumbing clean before making final connections to dental equipment.

15 1/2 “

(39.4 cm)

7.3“

(18.5 cm)

15 1/2 “

(39.4 cm)

ATTENTION: Junction Box Must be Positioned

Within Reach of the Umbilical.

Style A

midmark.com

English-5

TP200 Rev. A

4.75"

(12.1 cm)

1.5"

(3.8 cm)

1.75"

(4.4 cm)

Water

Air

Electrical

15.48"

(39.3 cm)

15.48"

(39.3cm)

Universal Power Supply

7.74"

(19.7cm)

Umbilical

7.74"

(19.7 cm)

.25"

(0.6 cm)

2.00"

(5.1 cm)

Junction Box Template - Not to Scale

Note: Full Size Templates is included with Junction Box

Style A

midmark.com

English-6

TP200 Rev. A

Solo

Fan

Dimensions

Width 12.75 inches (32.4 cm)

Length 20.89 inches (53 cm)

Height 11.40 inches (29 cm)

Weight 54 lbs ( 24.5 kg)

Shipping Weight 61 lbs ( 27.7 kg)

Electrical

Voltage 115 VAC

Frequency 60 Hz

Circuit Breaker Protection 15 amps

Hospital Grade Wiring NEMA type: 14 and 18 AWG

Accessory Outlet (Side Mounted,

User Specs)

GFCI 5 amps, 125 VAC

Receptacles (Internal) NEMA Outlet, Snap AC Connector,

15 amp, 125 VAC

Plug 15 amps, 125 VAC

Power Cord Length 5 ft. NEMA 5-15R

Compressor

Motor Oil Free 1/3 HP

Working Pressure 80 - 100 PSI

Flow Rate 2.6 scfm @ 45 PSI

Sound Level (full load) < 55 dB

Air Tank 1 gal 3.79 Liter

Water Connection

Water Inlet Length 10 ft. (3 m)

Water Inlet Thread Size 3/8” FNPT

Saddle Valve Adapter Length 2 ft. (.61 m)

Saddle Clamp Range

3/8” - 1

5/16

” OD Copper Pipe

Accessory Outlet

On / Off Switch

Drain Valve

City Water Inlet

Connection

Umbilical & Foot

Control Cord

Entry

Specications

Style A

midmark.com

Midmark VetPro 5000 Mounted Dental Delivery System Installation guide

Brand: Midmark

Model: VetPro 5000 Mounted Dental Delivery System

Type: Installation guide

This manual is also suitable for

VetPro Solo

Download PDF

report

Midmark VetPro 5000 Mounted Dental Delivery System Installation guide

This manual is also suitable for

Midmark VetPro 5000 Mounted Dental Delivery System Installation guide

Related papers

Other documents