2. Computers & electronics
  3. TVs & monitors
  4. Wall & ceiling mounts accessories
  5. Screen Innovations
  6. Side and Sill Channel

Screen Innovations Side and Sill Channel Installation guide

  • Hello! I'm here to assist you with the Screen Innovations Side & Sill Channels installation instructions. I have read the document and understand that it provides step-by-step instructions for mounting, securing, and removing the channels. I can help with any questions you may have about the installation process or the tools required.
  • What should be done before installing Side & Sill Channels?
    Where should the side channels be aligned?
    What tool is required to secure the covers?
    What tool is used to remove the channels?
INSTALLERS: Please leave this manual with the owner.
Side & Sill Channels
Outside Mount
Installation Instructions
Visit screeninnovations.com/support for assistance, other instructions, videos and more.
Pg 1Parts List- Side & Sill Channels (Outside Mounting)
PARTS LIST - Side & Sill Channels (Outside Mounting)
Side Channels with brush
(2 sets - 4 pieces.)
Sill Mounting Channels
(1 set - 2 pieces.)
Channels
Brackets (2 per channel)
Side Channel Removal Tool
Wood Screws
Install Tool
Installation Tools
INSTALLATION - Side Channels (Outside Mounting)
Install channels under the box shade, aligned to the edge of the end caps. Secure channels
to wall with included screws in each of the drilled holes. Repeat same for opposite side of
window.
1
Pg 2
Installation - Side Channels (Outside Mounting)
Note: Install the Nano Box shade prior to installing Side & Sill Channels.
Predrill holes 3” from each end and add few more holes approximately 12” apart over length.
Rear mounting will be used on outside mount installations.
INSTALLATION - Side Channels (Outside Mounting)
Roll down the shade, checking to ensure the fabric doesn’t drag or rub th einside of the
channel.
Install the covers.
2
Pg 3Installation - Side Channels (Outside Mounting)
Installation - Side Channels (Outside Mounting) Pg 6
INSTALLATION - Side Channels (Outside Mounting)
3To secure the covers, use the supplied install tool. Using a mallet, tap the tool to snap the
outside extrusion into the mounted extrusion.
Note: This could take quite a bit of force.
Once started work your way down continuing to tap the tool to seat the extrusion
Repeat for the other side.
Pg 5
4
INSTALLATION - Sill Channels (Optional)
Installation - Sill Channels (Outside Mounting)
Optional - Install the sill channel at the bottom
Secure the channel covers to wall with included screws in each of the drilled holes.
INSTALLATION - Sill Channels (Optional)
Removal - Side & Sill Channels (Outside Mounting) Pg 7
REMOVAL - Side & Sill Channels (Outside Mounting)
5If a need arises to remove the extrusion, use the side channel removal tool.
Make sure the shade is rolled up to prevent damage.
Starting at the top or bottom, insert the tool into channel at an angle as shown. Make sure
the tool is as far into the channel as possible and pry the channel apart by rotating the tool
down. Repeat every few inches untill the side channels are fully seperated.
Screen Innovations
9715-B Burnet Rd, Suite 400 Austin, TX 78758
512.832.6939
www.screeninnovations.com
400141 | v. 1.4 | 4 November 2020
/