2. Computers & electronics
  3. TVs & monitors
  4. Wall & ceiling mounts accessories
  5. Screen Innovations
  6. Side and Sill Channel

Screen Innovations Side and Sill Channel Installation guide

  • Hello! I'm your chat assistant, and I've reviewed the installation instructions for the Screen Innovations Side & Sill Channels Inside Mount. This document provides detailed steps for mounting the side and sill channels, ensuring proper fabric movement and cover installation, along with instructions for removing the extrusions. I'm ready to assist you with any questions you may have about the device or its setup.
  • What should I do before installing the Side & Sill Channels?
    How far apart should I predrill holes when installing side channels?
    What should I check after installing the side channels?
    What tool should I use to secure the covers?
    What should I do before removing the side extrusions?
INSTALLERS: Please leave this manual with the owner.
Side & Sill Channels
Inside Mount
Installation Instructions
Visit screeninnovations.com/support for assistance, other instructions, videos and more.
PARTS LIST - Side & Sill Channels (Inside Mounting)
Pg 1Parts List- Side & Sill Channels (Inside Mounting)
Side Channels with brush
(2 sets - 4 pieces.)
Sill Mounting Channels
(1 set - 2 pieces.)
Channels
Brackets (2 per channel)
Side Channel Removal Tool
Wood Screws
Install Tool
Installation Tools
INSTALLATION - Side Channels (Inside Mounting)
Slide extrusion up against box shade and secure to wall with included screws in each of the
drilled holes. Repeat same for opposite side of the window.
Note: Install the Nano Box shade prior to installing Side & Sill Channels.
Predrill holes 3” from each end and add more holes approximately 12” apart over length.
Side mounting will be used on inside mount installations.
1
Installation - Side Channels (Inside Mounting) Pg 2
Roll down the shade, checking to ensure the fabric doesn’t drag or rub th einside of the
channel.
Install the covers.
Pg 3
2
INSTALLATION - Side Channels (Inside Mounting)
Installation - Side Channels (Inside Mounting)
INSTALLATION - Side Channels (Inside Mounting)
To secure the covers, use the supplied install tool. Using a mallet, tap the tool to snap the
outside extrusion into the mounted extrusion.
Note: This could take quite a bit of force.
Once started work your way down continuing to tap the tool to seat the extrusion
Repeat for the other side.
3
Installation - Side Channels (Inside Mounting) Pg 4
Optional - Install the sill channel at the bottom.
Secure the channel covers to wall with included screws in each of the drilled holes.
Pg 3
4
INSTALLATION - Sill Channels (Optional)
Installation - Sill Channels (Inside Mounting)
Removal - Side & Sill Channels (Inside Mounting) Pg 6
REMOVAL - Side & Sill Channels (Inside Mounting)
If a need arises to remove the extrusion, use the side channel removal tool.
Make sure the shade is rolled up to prevent damage.
Starting at the top or bottom, insert the tool into channel at an angle as shown. Make sure
the tool is as far into the channel as possible and pry the channel apart by rotating the tool
down. Repeat every few inches untill the side channels are fully seperated.
5
Screen Innovations
9715-B Burnet Rd, Suite 400 Austin, TX 78758
512.832.6939
screeninnovations.com
400140 | v. 1.4 | 4 November 2020
/