2. FSR
  3. FL-500P-BRS

FSR FL-500P-BRS Installation guide

  • Hello! I've reviewed the installation instructions for the FSR FL-500P and FL-600P covers. This document details how to properly install these floor box covers, including steps for removing the temporary cover, sealing the edges, and securing the new cover with screws and O-rings. It also explains how to use the cable access door. I'm here to help if you have any questions about the installation process or the features of the covers.
  • What should be done with the temporary cover?
    What type of sealant is used during installation?
    How is the cover secured?
    How is the cover removed?
FSR 244 Bergen Boulevard, Woodland Park, NJ 07424, Phone: 973.785.4347 - Fax: 973.785.4207
43051 LIT1479
1. REMOVE AND DISCARD TEMPORARY COVER AND SCREWS.
TEMPORARY COVER
(8) FLAT HEAD SCREW
2. INSTALL CABLE INTERFACES AND CONNECTOR PLATES IF PREVIOUSLY
NOT INSTALLED. CLEAN AREA IN AND AROUND ENTIRE TOP EDGE OF
BOX AND APPLY 1/4" CONTINUOUS BEAD OF RTV SILICONE SEALANT.
CLEAN AND APPLY SEALANT
AROUND ENTIRE EDGE
CLEAN AND APPLY SEALANT
AROUND ENTIRE EDGE
COVER
(8) O-RING
(8) FLAT HEAD SCREW
3. INSTALL COVER WITH SUPPLIED O-RINGS AND FLAT HEAD SCREWS.
INSTALL FINISHED FLOORING MATERIAL.
FL-500P/600P COVER INSTALLATION INSTRUCTIONS
4. REMOVE COVER BY LIFTING AND PULLING HANDLE UPWARD AS
SHOWN (CABLE ACCESS DOOR WILL FALL INWARD IF NOT ALREADY
OPEN). COVER CAN NOW BE PLACED FLAT ON FLOOR. CONNECT
CABLES AS REQUIRED. PRIOR TO REINSTALLING COVER, SWING
CABLE ACCESS DOOR ONTO VELCRO ON UNDERSIDE OF COVER.
REVERSE COVER REMOVAL STEPS TO REINSTALL COVER AND PUSH
FIRMLY ON CORNERS TO SNAP COVER SECURELY IN PLACE.
CABLE ACCESS DOOR
HANDLE COVER
COVER SHOWN WITH CABLE
ACCESS DOOR OPEN
COVER TAB
RIM TAB
WHEN REINSTALLING COVER
BE SURE TO INSERT COVER TABS
INTO OPENING ABOVE RIM TABS
OPENING
/