Read and understand all instruction, warning, and danger labels.
IMPORTANT: READ OPERATOR'S MANUAL AND ENGINE MANUAL THOROUGHLY AND
FOLLOW THE SAFE OPERATION PRACTICES BEFORE OPERATING .
Lea el manual de operación anexo sobre ensamblaje e inicio.
Need Help? Call 1-888-TO-HELP-U (1-888-864-3578)
Use cable tie to
secure cables to
lower handle.
1
2
3
4
Refer to Operator’s Manual for instructions on attaching the grass catcher.
778-11521© 2007 12AE449
Blade Control Handle
(A) Lift handle
to extended
position.
(B) Tighten
star knobs.
Recoil
Starter
Star Knobs
A
B
Wing Nuts (2)
Hardware Pack
Carriage Bolts (2)
A
B
C
D
(A) Hold blade
control handle
against upper
handle.
(B)(C) Slowly
slip recoil starter
into rope guide.
(D) Tighten rope
guide wing knob.
Place ends of lower
handle onto handle
brackets. Insert
carriage bolts and
tighten with wing
nuts.
Read and understand all instruction, warning, and danger labels.
IMPORTANT: READ OPERATOR'S MANUAL AND ENGINE MANUAL THOROUGHLY AND
FOLLOW THE SAFE OPERATION PRACTICES BEFORE OPERATING .
Lea el manual de operación anexo sobre ensamblaje e inicio.
Need Help?
Call 1-888-TO-HELP-U
Lea el manual de operación anexo sobre ensamblaje e inicio.
Fill tank with gas to within 1/2 inch of top of tank.
Fill engine with entire contents of oil bottle supplied.
5
6
Push primer ve times.
7
Gas Cap
Oil Fill
Primer
Depress blade control handle and hold.
9
8
Pull recoil starter with quick, full armstroke. If engine
does not start after ten seconds of repeated pulls,
repeat steps 7 through 9.
Electric start battery must be charged for 8-10
hours before initial use. See Maintenance Section in
Operator’s Manual.
/