Bolens 11A-074E065 Quick start guide

Type
Quick start guide

This manual is also suitable for

Read and understand all instruction, warning, and danger labels.
IMPORTANT: READ OPERATOR'S MANUAL AND ENGINE MANUAL THOROUGHLY AND
FOLLOW THE SAFE OPERATION PRACTICES BEFORE OPERATING .
Lea el manual de operación anexo sobre ensamblaje e inicio.
Need Help? Call 1-888-TO-HELP-U (1-888-864-3578)
(A) Remove
retainer clip
from chute
deector and
discard clip.
(B) Lift
handle to
extended
position.
(C) Tighten
star knobs.
1
2
Starter
Rope
Blade Control Handle
Star Knobs
Chute
Deector
Tools Required for Assembly: A set
of adjustable wrenches or individual
wrenches of the following sizes:
9/16-inch and 3/4-inch
Secure rear wheels to deck as shown. The bell
washer should be installed with the crown side facing
the wheel. Secure front wheels in same manner.
(A) Hold blade
control handle
against upper
handle.
(B)(C) Slowly
pull starter rope
from engine and
slip starter rope
into rope guide.
(D) Tighten rope
guide wing knob.
Use cable
tie to secure
cable to lower
handle.
3
4
778-11651
© 200811A-074
B
A
C
A
C
D
B
Read and understand all instruction, warning, and danger labels.
IMPORTANT: READ OPERATOR'S MANUAL AND ENGINE MANUAL THOROUGHLY AND
FOLLOW THE SAFE OPERATION PRACTICES BEFORE OPERATING .
Lea el manual de operación anexo sobre ensamblaje e inicio.
Need Help?
Call 1-888-TO-HELP-U
Lea el manual de operación anexo sobre ensamblaje e inicio.
Fill tank with
gas up to within
1/2-inch of top
of tank. Do not
overll.
Fill engine with
entire contents of
oil bottle supplied.
Do not overll.
5
6
Push primer
ve times.
7
Gas Cap
Oil Fill
Primer
Depress blade control handle and hold.
Pull starter rope with quick, full arm stroke. If engine
does not start after ve pulls, repeat steps 7 through 9.
9
8
  • Page 1 1
  • Page 2 2

Bolens 11A-074E065 Quick start guide

Type
Quick start guide
This manual is also suitable for

Ask a question and I''ll find the answer in the document

Finding information in a document is now easier with AI