MTD 11A-074D765 Quick start guide

Category
Lawnmowers
Type
Quick start guide
IMPORTANT: READ OPERATOR'S MANUAL THOROUGHLY AND
FOLLOW THE SAFE OPERATION PRACTICES BEFORE OPERATING .
Read and understand all instruction, warning and danger labels.
Lea el manual de operación anexo sobre ensamblaje e inicio.
A
C
D
B
Need Help? Call 1-888-TO-HELP-U (1-888-864-3578)
Secure rear wheels to deck as shown. Be sure to
place cupped side of washer against deck.
Secure front wheels in same manner.
Secure cable to lower handle with
cable tie provided with unit.
Lift handle to extended position. Tighten wing knobs.
Remove retainer clip from chute deflector.
Hold blade control handle against upper handle.
Slowly slip starter rope into rope guide.
Tighten rope guide wing knob.
Starter
Rope
Blade Control Handle
Star Knobs
778-10716C© 2006 11A-074D765
Shoulder
Screw
Small
Washer
Large Washer
Hex
Nut
Wheel
Deck
Shoulder Screw
Small
Washer
Large
Washer
Hex
Nut
A
B
Chute
Deflector
Tools Required for
Assembly: A set of
adjustable wrenches
or individual wrenches
of the following sizes:
9/16-inch and 3/4-inch
IMPORTANT: READ OPERATOR'S MANUAL THOROUGHLY AND
FOLLOW THE SAFE OPERATION PRACTICES BEFORE OPERATING .
Read and understand all instruction, warning and danger labels.
Lea el manual de operación anexo sobre ensamblaje e inicio.
Push primer five times.
(1-888-864-3578)
Fill tank with gas to within 1/2 inch of top of tank.
Depress blade control handle and hold.
Fill engine with entire contents of oil
bottle supplied with your mower.
Pull starter rope with quick, full arm stroke.
If engine does not start after five pulls,
repeat steps seven thru nine.
Call 1-888-TO-HELP-U
Need Help?
Gas Cap
Oil Fill
Primer
  • Page 1 1
  • Page 2 2

MTD 11A-074D765 Quick start guide

Category
Lawnmowers
Type
Quick start guide

Ask a question and I''ll find the answer in the document

Finding information in a document is now easier with AI