Troy-Bilt 12AJ836G211, 12AJ836E011 Fast Start Guide

  • Hello! I am an AI chatbot trained to assist you with the Troy-Bilt 12AJ836G211 Fast Start Guide. I’ve already reviewed the document and can help you find the information you need or explain it in simple terms. Just ask your questions, and providing more details will help me assist you more effectively!
Read and understand all instruction, warning, and danger labels.
IMPORTANT: READ OPERATOR'S MANUAL AND ENGINE MANUAL THOROUGHLY AND
FOLLOW THE SAFE OPERATION PRACTICES BEFORE OPERATING .
Lea el manual de operación anexo sobre ensamblaje e inicio.
Need Help? Call 1-888-TO-HELP-U (1-888-864-3578)
Use cable
tie to secure
cables to
lower handle.
1
2
3
4
Refer to Operator’s Manual for instructions on attaching the grass catcher.
12AJ836 © 2007
778-11523
Starter
Rope
Blade Control
Handle
Star Knobs
(A) Hold blade
control handle
against upper
handle.
(B)(C) Slowly
slip starter
rope into rope
guide.
(D) Tighten
rope guide
wing knob.
(A) Lift handle
to extended
position.
(B) Tighten star
knobs.
A
B
B
Tighten
star knobs
to secure
lower handle
to handle
brackets.
A
C
D
B
Electric start battery must be charged for 8-10 hours before initial use. Refer
to Operators Manual for charging instructions.
Read and understand all instruction, warning, and danger labels.
IMPORTANT: READ OPERATOR'S MANUAL AND ENGINE MANUAL THOROUGHLY AND
FOLLOW THE SAFE OPERATION PRACTICES BEFORE OPERATING .
Lea el manual de operación anexo sobre ensamblaje e inicio.
Need Help?
Call 1-888-TO-HELP-U
Lea el manual de operación anexo sobre ensamblaje e inicio.
Fill tank with gas to within 1/2-inch of
top of tank.
Fill engine with entire contents of oil bottle
supplied.
5
6
Need Help?
Call 1-888-TO-HELP-U
Gas Cap
Oil Fill
Depress blade control handle and hold.
8
7
If the battery has been charged for 8-10 hours,
turn the key to start the mower. If the battery has
not been charged, pull starter rope with quick,
full arm stroke. If engine does not start after ten
seconds of repeated pulls, wait a few minutes and
repeat steps 7 through 8.
Electric start battery must be charged for 8-10 hours before
initial use. Refer to Operators Manual for charging instructions.
/