Troy-Bilt 11A436N211 Fast Start Guide

Type
Fast Start Guide

This manual is also suitable for

Read and understand all instruction, warning, and danger labels.
IMPORTANT: READ OPERATOR'S MANUAL AND ENGINE MANUAL THOROUGHLY AND
FOLLOW THE SAFE OPERATION PRACTICES BEFORE OPERATING .
Lea el manual de operación anexo sobre ensamblaje e inicio.
Need Help? Call 1-888-TO-HELP-U (1-888-864-3578)
778-11659
11A-436
1
2
Use cable
tie to secure
cable to lower
handle.
4
3
Starter
Rope
Refer to Operator’s Manual for instructions on attaching the grass catcher.
© 2008
Star Knobs
Blade Control Handle
(A) Lift handle
to extended
position.
(B) Tighten star
knobs.
(A) Hold blade
control handle
against upper
handle.
(B)(C) Slowly pull
starter rope from
engine and slip
starter rope into
rope guide.
(D) Tighten rope
guide wing knob.
Place ends of
lower handle
onto handle
brackets.
Insert carriage
bolts and
tighten with
wing nuts.
A
B
A
C
D
B
Read and understand all instruction, warning, and danger labels.
IMPORTANT: READ OPERATOR'S MANUAL AND ENGINE MANUAL THOROUGHLY AND
FOLLOW THE SAFE OPERATION PRACTICES BEFORE OPERATING .
Lea el manual de operación anexo sobre ensamblaje e inicio.
Need Help?
Call 1-888-TO-HELP-U
Lea el manual de operación anexo sobre ensamblaje e inicio.
Fill tank with gas to within 1/2 inch of top of tank.
Fill engine with entire contents of oil bottle supplied
with your mower.
5
6
7
Gas Cap
Oil Fill
Gas Cap
Oil Fill
Fill tank with gas up to within 1/2-inch
of top of tank. Do not overll.
Fill engine with entire contents of oil bottle
supplied. Do not overll.
5
6
Need Help?
Call 1-888-TO-HELP-U
Depress blade control handle and hold.
7
8
Pull recoil starter with quick, full arm stroke.
If engine does not start after ten seconds of
repeated pulls, wait a few minutes and repeat.
  • Page 1 1
  • Page 2 2

Troy-Bilt 11A436N211 Fast Start Guide

Type
Fast Start Guide
This manual is also suitable for

Ask a question and I''ll find the answer in the document

Finding information in a document is now easier with AI