Troy-Bilt 12AI867Q011 Fast Start Guide

Type
Fast Start Guide

This manual is also suitable for

Read and understand all instruction, warning, and danger labels.
IMPORTANT: READ OPERATOR'S MANUAL AND ENGINE MANUAL THOROUGHLY AND
FOLLOW THE SAFE OPERATION PRACTICES BEFORE OPERATING .
Lea el manual de operación anexo sobre ensamblaje e inicio.
Need Help? Call 1-888-TO-HELP-U (1-888-864-3578)
Use cable
tie to secure
cables to
lower handle.
1
2
3
4
Refer to Operator’s Manual for instructions on attaching the grass catcher.
12AI86 © 2007
778-11502
Starter
Rope
Blade Control
Handle
Star Knobs
(A) Hold blade
control handle
against upper
handle.
(B)(C) Slowly
slip starter
rope into rope
guide.
(D) Tighten
rope guide
wing knob.
(A) Lift handle
to extended
position.
(B) Tighten star
knobs.
(A) Move
hairpin clip to
inside hole.
(B) Insert
carriage bolt
and tighten
with wing nut.
Repeat on
opposite side.
A
B
B
A
C
D
B
A
B
Read and understand all instruction, warning, and danger labels.
IMPORTANT: READ OPERATOR'S MANUAL AND ENGINE MANUAL THOROUGHLY AND
FOLLOW THE SAFE OPERATION PRACTICES BEFORE OPERATING .
Lea el manual de operación anexo sobre ensamblaje e inicio.
Need Help?
Call 1-888-TO-HELP-U
Lea el manual de operación anexo sobre ensamblaje e inicio.
Fill tank with gas to within 1/2-inch of top of tank.
Open fuel valve.
5
6
7
Fill engine with oil to upper limit of dipstick. Check
oil level by inserting (and not threading) dipstick into
ller neck.
Gas Cap
Fuel Valve
Oil Fill
Depress blade control handle and hold.
9
8
Pull starter rope with quick, full arm stroke.
If engine does not start after ten seconds of repeated
pulls, wait a few minutes and repeat steps 8 through 9.
  • Page 1 1
  • Page 2 2

Troy-Bilt 12AI867Q011 Fast Start Guide

Type
Fast Start Guide
This manual is also suitable for

Ask a question and I''ll find the answer in the document

Finding information in a document is now easier with AI