2. Troy-Bilt
  3. 24BF572B711
24BF572B711

Troy-Bilt 24BF572B711 Fast Start Guide

  • Hello! I am an AI chatbot trained to assist you with the Troy-Bilt 24BF572B711 Fast Start Guide. I’ve already reviewed the document and can help you find the information you need or explain it in simple terms. Just ask your questions, and providing more details will help me assist you more effectively!
1
2
778-11825A© 2010 24BF572B
Release the A.
beam lock.
Remove the spring A.
clip and clevis pin.
Pivot jack stand B.
into operating
position.
Secure the jack C.
stand with the
spring clip and
clevis pin.
Remove the hardware from the tank
bracket. Align holes of tongue with
holes in tank bracket and secure with
the hardware just removed.
Lift and slide
the cylinder
to the top of the beam
and onto the bracket.
Remove the dislodger.A.
Remove the log tray and two adjacent B.
screws from the left side of the beam.
Re-attach the dislodger.A.
Re-attach the log tray.B.
BA
Jack Stand
Cylinder
Tongue
Dislodger
Control
Handle
Wedge
Beam
Log Tray
B
A
Pivot the B.
beam
downward
into the
horizontal
position
and lock.
A
IMPORTANT: Carefully follow all uncrating steps.
Refer to Operator’s Manual for instructions.
B
1
4
2
5
3
6
READ AND UNDERSTAND ALL INSTRUCTION, WARNING, AND DANGER LABELS.
PARA INSTRUCCIONES EN ESPAÑOL, REFIÉRASE AL MANUAL DEL OPERADOR.
IMPORTANT: READ OPERATOR'S MANUAL AND ENGINE MANUAL THOROUGHLY
AND FOLLOW THE IMPORTANT SAFE OPERATION PRACTICES BEFORE OPERATING.
Need Help? Call 1-888-TO-HELP-U
778-11825A© 2010 24BF572B
Rotate the Engine Stop Switch
to the ON position.
Fill tank with gas to bottom of fuel level limit
in the neck of the fuel tank. Do not overfill.
Turn fuel valve to ON position.
Grasp the Starter Rope Handle and pull with a
quick, full arm stroke.
If engine does not start after ten seconds of
repeated pulls, wait a few minutes and repeat.
Push the Choke Control inward after engine starts.
IMPORTANT: Check engine oil, lubricate beam,
check hydraulic fluid level and prime the pump before operating.
Refer to Operator’s Manual for instructions.
Starter Rope
Handle
Gas Cap
Choke Rod
Engine Stop
Switch
Fuel Valve
Remove the bow-tie clip and clevis pin
from the control handle.
B
C
A
Pivot the control handle upwardA.
Reinsert the B.
clevis pin.
Secure the control handle C.
with the bow-tie clip.
OFF
ON
Pull the Choke Rod outward.
7
10
8
11
9
12
READ AND UNDERSTAND ALL INSTRUCTION, WARNING, AND DANGER LABELS.
PARA INSTRUCCIONES EN ESPAÑOL, REFIÉRASE AL MANUAL DEL OPERADOR.
IMPORTANT: READ OPERATOR'S MANUAL AND ENGINE MANUAL THOROUGHLY
AND FOLLOW THE IMPORTANT SAFE OPERATION PRACTICES BEFORE OPERATING.
Need Help? Call 1-888-TO-HELP-U
/