Troy-Bilt 24BF572B711 Fast Start Guide

24BF572B711
Troy-Bilt
Brand
Troy-Bilt
Model
24BF572B711
Type
Fast Start Guide
IMPORTANT: READ OPERATOR'S MANUAL THOROUGHLY AND
FOLLOW THE SAFE OPERATION PRACTICES BEFORE OPERATING .
Read and understand all instruction, warning, and danger labels.
Lea el manual de operación anexo sobre ensamblaje e inicio.
Need Help? Call 1-888-TO-HELP-U (1-888-864-3578)
Pivot beam to horizontal
position and lock.
Pivot jack stand to
operating position.
Remove hardware from tank bracket. Align holes of
tongue with those in bracket and secure with hardware
just removed.
Remove dislodger and log cradle as shown.
Re-attach dislodger and log cradle.
778-11261A
© 2007 24BF572B
Jack Stand
Cylinder
Tongue
Dislodger
Control Handle
Wedge
Beam
Log Cradle
1
2
3
4
5
6
1
2
A
B
Lift and slide
cylinder to top
of beam and into
weld brackets.
IMPORTANT: Lubricate beam, adjust wedge assembly, and check hydraulic
fluid before operating. Refer to Operator’s Manual for instructions.
IMPORTANT: READ OPERATOR'S MANUAL THOROUGHLY AND
FOLLOW THE SAFE OPERATION PRACTICES BEFORE OPERATING .
Read and understand all instruction, warning, and danger labels.
Lea el manual de operación anexo sobre ensamblaje e inicio.
Turn engine switch to ON position.
Fill tank with gas to within 1/2 inch of top of tank. Open
fuel valve.
Pull starter rope with quick, full armstroke. If engine
does not start after ten seconds of repeated pulls, wait
a few minutes and repeat.
Need Help?
Call 1-800-800-7310
Pull CHOKE out.
Choke
Push CHOKE in after engine starts.
7
8
9
10
11
IMPORTANT: Lubricate beam, adjust wedge assembly, and check hydraulic
fluid before operating. Refer to Operator’s Manual for instructions.
  • Page 1 1
  • Page 2 2

Troy-Bilt 24BF572B711 Fast Start Guide

24BF572B711
Troy-Bilt
Brand
Troy-Bilt
Model
24BF572B711
Type
Fast Start Guide
Download PDF
report

Ask a question and I''ll find the answer in the document

Finding information in a document is now easier with AI

Related papers

Other documents