Troy-Bilt 24BF572B711 Fast Start Guide

Type
Fast Start Guide
IMPORTANT: READ OPERATOR'S MANUAL THOROUGHLY AND
FOLLOW THE SAFE OPERATION PRACTICES BEFORE OPERATING .
Read and understand all instruction, warning and danger labels.
Lea el manual de operación anexo sobre ensamblaje e inicio.
Need Help? Call 1-888-TO-HELP-U (1-888-864-3578)
Pivot beam to horizontal position and lock.
778-11261© 2006 24BF572B711
Pivot jack stand to
operating position.
Remove hardware from tank
bracket. Align holes of tongue with
those of bracket and secure with
hardware just removed.
Remove dislodger and log cradle as shown.
1
2
A
B
Lift and slide cylinder to top of
beam and into weld brackets.
Re-attach dislodger and log cradle.
Jack
Stand
Cylinder
Tongue
Dislodger
Control
Handle
Wedge
Beam
Log Cradle
IMPORTANT: READ OPERATOR'S MANUAL THOROUGHLY AND
FOLLOW THE SAFE OPERATION PRACTICES BEFORE OPERATING .
Read and understand all instruction, warning and danger labels.
Lea el manual de operación anexo sobre ensamblaje e inicio.
Turn engine switch to ON position.
Fill tank with gas to within 1/2 inch of top of tank.
Open fuel valve.
Pull starter rope with quick, full armstroke. If engine
does not start after ten seconds of repeated pulls,
repeat steps seven through ten.
Need Help?
Call 1-800-800-7310
Pull CHOKE out.
Choke
Push CHOKE in once engine starts.
Gas Cap
Fuel Valve
Engine
Switch
  • Page 1 1
  • Page 2 2

Troy-Bilt 24BF572B711 Fast Start Guide

Type
Fast Start Guide

Ask a question and I''ll find the answer in the document

Finding information in a document is now easier with AI