Ghent PNT1UM7736BLKWH Installation guide

Type
Installation guide
(1)
5/32" Hex
Wrench
Pointe Mobile Board / PNT
Installation Instructions
www.ghent.com/install - Lebanon, Ohio 800-543-0550
IS-PNT 07/21
Step 1:
Remove and unpack the Panel, Feet, Casters, and Hardware.
Step 2:
Lay the Panel on a flat surface.
(1)
Panel
(2)
Feet
(4)
Casters
(4)
1/4"-20 x 3/4"
Flat Head Cap Screw
(2)
#10-24 x 5/8"
Thumb Screw
(1)
Connector Plate
Step 3:
Slide the Feet into the bottom of the frame. Secure the feet to the frame using the
Flat Head Cap Screws. Tighten on the side of the Frame using the provided Hex Wrench.
www.ghent.com/install - Lebanon, Ohio 800-543-0550
IS-PNT 07/21
Step 7:
Recycle all packaging in accordance with local regulations.
Step 5:
Carefully stand Pointe Mobile Board upright.
Step 4:
Attach the Casters to the bottom of the feet.
Step 6:
(Optional) Use provided connector plate and thumb screws when connecting Pointe units to
create a partition.
  • Page 1 1
  • Page 2 2

Ghent PNT1UM7736BLKWH Installation guide

Type
Installation guide

Ask a question and I''ll find the answer in the document

Finding information in a document is now easier with AI