2. Ghent
  3. DFP3-5747-FP

Ghent DFP3-5747-FP, DFP1-5747-C, DFP1-5747-FP, DFP1-5747-M1, DFP2-5747-C, DFP2-5747-FP, DFP2-5747-M1, DFP3-5747-C, DFP3-5747-M1 Operating instructions

  • Hello! I've reviewed the instruction sheet for the Ghent Desk to Floor Partition model DFPX-5747-XX. This document provides a clear, step by step guide on assembling and installing the partition, from unpacking to ensuring a level setup. I'm ready to answer your questions about the assembly process or the product itself.
  • What is the first step in assembling the desk to floor partition?
    What tool is needed to assemble the partition?
    How do you level the partition after installation?
Insert tee nut onto frame and
slide to the top. Hand tighten.
B
G
Desk to Floor Partition / DFPX-5747-XX
Instruction Sheet
Step 1:
Remove and unpack carton contents.
Step 2:
Attach Desk Clamp Bracket:
- Lay Desk Floor Partition assembly on a padded surface.
- Insert Clamp assembly with hardware as shown.
Step 3:
Pre-assemble screw and tee nut onto foot as shown, slide foot onto frame and hand tighten.
IS-DFP 10/20
www.ghent.com/install - Lebanon, OH 800-543-0550
(1)
Desk Floor Partition
Assembly
(2)
Feet
(1)
Desk Clamp
Assembly
(3)
1/4"-20 X 3/8 Button
Head Cap Screw
(3)
1/4"-20 Tee Nut
(1)
5/32" Allen
Wrench
Flat side of nut
towards screw head,
hand tight
Flat side of nut towards
screw head
Put screw through clamp and
attach tee nut. Do not tighten.
Desktop
No gap
Tighten clamp
Tighten feet
Desk to Floor Partition / DFPX-5747-XX
Instruction Sheet
IS-DFP 10/20
www.ghent.com/install - Lebanon, OH 800-543-0550
Step 5:
Recycle all packing materials in accordance with local regulations.
Step 4:
Position the Desk to Floor Partition on the desk or table at the desired location. Tighten
screws and adjust feet as necessary for a level and secure installation.
Desk
Partition
Floor
Partition
/