Assembly Instructions: 2635-6 (Amari)

IMPORTANT:

• ALL INSTALLATION WORK SHOULD BE DONE BY ACCREDITED PROFESSIONAL.

• SHUT OFF POWER SUPPLY AT FUSE OR CIRCUIT BREAKER!

• USE ONLY THE SPECIFIED BULBS. DO NOT EXCEED THE MAXIMUM WATTAGE!

PREPARING FOR INSTALLATION

Remove all of the contents from the carton. See the important

notes above. Shut off the power at the circuit breaker and

completelyremovetheoldxturefromtheceiling,includingthe

placecanopy(F)overthemountingstrap.Testwhethermounting

screws(A)lineupwiththeholesincanopy(F).Placethexture

andcanopyasideandsecuremountingstrap(B)tothejunction

boxwithmountingscrews(D)andascrewdriver.Tightenthe

screws securely.

3.Therearefoursteelcablewires(K)whichrunfromthexture’s

frame(P)upthroughholesincanopy(F).Bymeasuring,determine

thecorrectlengthofsteelcablewires(K)neededforproper

hangingheight.Toshortenthexture,depressbutton(H)andpull

theexcesscablewires(K)upthroughcanopy(F).Tolengthen

Treat the xture gently! Regular cleaning will reduce the need for deep cleaning. For regular cleaning, turn off the light and wipe down the

xture with a clean lint-free cotton or microber cloth. Never spray cleaner directly onto the xture.

For Customer Service, contact

the place of purchase to arrange

for replacement parts.

House Wires

Fixture Wires

Hot

How to Identify the Fixture’s Wires

Hot Neutral Ground

White Inner

Thread

FINISHING THE INSTALLATION

5.Raisecanopy(F)totheceiling.Positionthecanopysothatmountingscrews(A)protrudethroughtheopeningsofcanopy(F).

Securecanopy(F)tomountingstrap(B)withdecorativenuts(G).

6.Carefullyplaceglassdiffusers(L)intotheopeningsonframe(P).Slidespacers(M)ontoscrews(N)andlocktheglassdiffusers(L)

intoplaceusingdecorativenuts(G2).

whitetowhite(orribbed);groundtoground(greenorcopper).Twistthe

endsofthewirepairstogether,thentwistonawireconnector.Makesure

alltwistsareinthesamedirection.Ifthereisnogroundwire(greenor

copper)fromthejunctionbox,locategroundscrew(E)onmountingstrap

(B)andwrapthexture’sgroundwirearoundthegreengroundscrew(E).

Useascrewdrivertosecuregroundscrew(E)ontothemountingbracket.

Tuckallwiresneatlyintothejunctionbox.