2. BARN DOOR HARDWARE
  3. SDH-SW4-BLK-8
SDH-SW4-BLK-8

BARN DOOR HARDWARE SDH-SW4-BLK-8 Installation guide

  • Hello! I've reviewed the installation manual for the CLASSIC STRAP SDH-SW4-BLK-8 Door Hardware Kit. This manual provides detailed instructions on how to install your new sliding door hardware, including mounting the rail, attaching the door, and installing the floor guide. I'm ready to answer your questions about the installation process and the hardware involved.
  • What tools are required for installation?
    What is included in the kit?
    What type of wall blocking is needed?
BARN
DOOR
HARDWARE
CLASSIC
STRAP
Hardware kit for sliding single wood door.
MODEL No. SDH-SW4-BLK-8 INSTALLATION MANUAL
TOOLS REQUIRED INCLUDED IN KIT
• Plumb Line
• Pencil
• Phillips Head Screwdriver
• 8mm Drill Bit
• 10mm Routing Drill Bit
• Wrench
• Level
• Tape Measure
• Power Drill
A
B
C
D
E
F
G H I
J K L
ADoor Roller Hardware x2
B96" Rail x1
CWall Bracket x6
D2.5mm Allen Key x1
EDoor Stop x2
FAnti-Jump Disk x2
GRouted Floor Guide x1
HFloor Anchor x2
IST4.2x25 Screw x2
JM8x30 Wall Anchor x6
KM8x60 Bolt + Washer x6
LM8x90 Bolt x6
Architectural Products by Outwater assumes no liability for improper installation.
CLASSIC STRAP
Wall Blocking
To obtain maximum weight capacity, all fasteners
must be mounted into solid wood studs or wall
blocking or mounted to a header board.
Minimum door overlap on guide is 4-3/4"
Find the centerline of the track. Using a level, mark a horizontal
line twice the door width long. Mark the bracket screw locations
into the wall blocking. Attach the wall portion of the brackets
as shown.
Attach the rail to the wall brackets using a wrench to
fasten the bolts as shown.
NOTES
Architectural Products by Outwater assumes no liability for improper installation.
Consult a structural engineer if you have questions
about what type of wall blocking is required.
Suggested wall bracket spacing. Brackets must be secured into wall blocking.
Drill out holes in the door using a 10mm routing drill bit as
pictured. The bottom of the door should be routed at this
time in order to accept the oor guide.
Attach the doors to the rails making sure that the
anti-jump disks are engaged to avoid a serious accident.
Plumb the door and mark the positions of the oor guides.
Mount the oor guides to the oor.
Attach the anti-jump disks to the tops of the door.
CLASSIC STRAP
Architectural Products by Outwater assumes no liability for improper installation.
Architectural Products by Outwater assumes no liability for improper installation.
CLASSIC STRAP
Adjust the door stops accordingly using the provided 2.5mm Allen key.
/