2. BARN DOOR HARDWARE
  3. SDH-SW4-BLK-8 Hardware Kit for Sliding Single Wood Door

BARN DOOR HARDWARE SDH-SW4-BLK-8 Hardware Kit for Sliding Single Wood Door Installation guide

  • Hello! I've reviewed the Installation Guide for the BARN DOOR HARDWARE SDH-SW4-BLK-8 Hardware Kit. This document outlines the steps for installing the hardware for a sliding single wood door, including finding the track centerline, attaching the rail and brackets, and mounting floor guides. I'm ready to assist with your questions about the hardware or installation process.
  • What tools are required for installation?
    What is the minimum door overlap on the guide?
    What should fasteners be mounted to?
Home » BARN DOOR HARDWARE » BARN DOOR HARDWARE SDH-SW4-BLK-8 Hardware Kit for Sliding Single
Wood Door Installation Guide
Contents
1 BARN DOOR HARDWARE SDH-SW4-BLK-8 Hardware Kit for Sliding Single Wood
Door
2 Hardware kit for sliding single wood door
3 INSTALLATION MANUAL
4 TOOLS REQUIRED
5 INCLUDED IN KIT
6 CLASSIC STRAP
7 Documents / Resources
8 Related Posts
BARN DOOR HARDWARE SDH-SW4-BLK-8 Hardware Kit for Sliding Single Wood Door
BARN DOOR HARDWARE SDH-SW4-BLK-8 Hardware Kit for
Sliding Single Wood Door Installation Guide
Manuals+ — User Manuals Simplified.
Hardware kit for sliding single wood door
MODEL No. SDH-SW4-BLK-8
INSTALLATION MANUAL
TOOLS REQUIRED
Plumb Line
Pencil
Phillips Head Screwdriver
8mm Drill Bit
10mm Routing Drill Bit
Wrench
Level
Tape Measure
Power Drill
INCLUDED IN KIT
ADoor Roller Hardware x2
B96″ Rail x1
CWall Bracket x6
D2.5mm Allen Key x1
EDoor Stop x2
FAnti-Jump Disk x2
GRouted Floor Guide x1
HFloor Anchor x2
IST4.2×25 Screw x2
JM8x30 Wall Anchor x6
KM8x60 Bolt + Washer x6
LM8x90 Bolt x6
Architectural Products by Outwater assumes no liability for improper installation.
CLASSIC STRAP
NOTES
Minimum door overlap on guide is 4-3/4″
To obtain maximum weight capacity, all fasteners must be mounted into solid wood studs or wall blocking or
mounted to a header board.
Consult a structural engineer if you have questions about what type of wall blocking is required.
1. Find the centerline of the track. Using a level, mark a horizontal line twice the door width long. Mark the bracket
screw locations into the wall blocking. Attach the wall portion of the brackets as shown.
2. Attach the rail to the wall brackets using a wrench to fasten the bolts as shown.
3. Drill out holes in the door using a 10mm routing drill bit as pictured. The bottom of the door should be routed at
this time in order to accept the floor guide.
4. Attach the anti-jump disks to the tops of the door.
5. Attach the doors to the rails making sure that the anti-jump disks are engaged to avoid a serious accident.
6. Plumb the door and mark the positions of the floor guides. Mount the floor guides to the floor.
7. Adjust the door stops accordingly using the provided 2.5mm Allen key.
Documents / Resources
BARN DOOR HARDWARE SDH-SW4-BLK-8 Hardware Kit for Sliding Single Wood Door [p
df] Installation Guide
SDH-SW4-BLK-8 Hardware Kit for Sliding Single Wood Door, SDH-SW4-BLK-8, Hardware Kit f
or Sliding Single Wood Door
Manuals+,
/