5019 418 33046
DDE 5790
DDE 5760
FIN
DKS N GB
1.
Control panel.
2.
Grease filter.
3.
Halogen bulbs.
4.
Steam deflector.
5.
Telescopic flue.
Cleaning the grease filter - Fig. 1
Wash the grease filter at least once a month.
1.
Disconnect the electrical power supply.
2.
Remove the grease filters: push the
handles back (
a
), and then downwards (
b
).
3.
After cleaning the grease filter refit in
reverse order, making sure the entire
extraction surface is covered.
Replacing bulbs - Fig. 2
1.
Disconnect the electrical power supply.
2.
Use a small screwdriver or any other
suitable tool to prise off the lamp cover.
3.
Remove the burnt-out bulb.
Replace using 20 W max halogen bulbs
only, making sure not to touch them with
your hands.
4.
Close the lighting unit (snap-close).
Carbon filter Fitting and
Maintenance
Fitting the carbon filter - Fig. 4
1.
Disconnect the electrical power supply.
2.
Remove the grease filters (
a
,
b - Fig. 1
).
3.
Turn the side knobs 90° and then remove
the filter holder (
g - Fig. 3
).
4.
Fit the carbon filter (
h - Fig. 4
) in the filter
holder (
h - Fig. 4
).
5.
Refit the filter holder and secure it to the
hood by turning the side knobs 90°
(
g - Fig. 3
).
6.
Refit the grease filter.
Carbon filter maintenance:
Unlike traditional carbon filters, this carbon
filter can be washed and reactivated.
With normal hood use, the filter should be
cleaned once a month. The best way to clean
the filter is in a dishwasher at the highest
temperature possible, using a normal
dishwasher detergent. To avoid particles of
food or dirt settling on the filter during
washing and giving rise to unpleasant smells,
it is advisable to wash the filter on its own.
After washing, dry the filter in the oven at
100° C for 10 minutes to reactivate it.
The filter will retain its odour-absorbing
capacity for three years, after which it will
have to be replaced.
CONTROL PANEL
A.
Light ON/OFF switch.
B.
ON/OFF and speed 1 selector switch
(small amount of steam and fumes).
B+C.
Speed 2 selector switch (medium amount
of steam and fumes).
B+D.
Speed 3 selector switch
(large amount of steam and fumes).