Any problems or questions call Regency Oce Furniture at 1-866-816-9822
IMPORTANT NOTICE:
Place all wooden parts on a clean and smooth surface such as a rug or carpet to avoid the parts from being scratched.
Check to be sure that you have all parts and hardware.
Remove all wrapping materials, including staples & packing straps before you start to assemble.
Do not tighten all screws/bolts until completely assembled.
Keep all hardware and packaging out of reach of children.
Organize your parts and hardware before you begin.
Impresa Swivel Recliner & Ottoman • N1701 • INSTRUCTIONS
F
A
E
H
G
B
C
E
D
Parts :
D: Cylinder
Quantity: 1
A: Seat Bottom
Quantity: 1
Quantity: 1
B: Back
Quantity: 1
Hardware :
G: Ottoman Top
Quantity: 1
F: Ottoman Base
Quantity: 1
E: Arms
Quantity: 2
H: Ottoman
Stem
Quantity: 1
I: 3” Bolt M: Nut
N: Knob & Washer
Quantity: 2
J: 2” Bolt
Quantity: 4
K: 1 3/16” Bolt
L: 13/16” Bolt
Quantity: 2 Quantity: 2
Quantity: 1
C: Chair Base
STEP 2: Place Seat Bottom(A) on to Cylinder(D)
by lining up hole with cylinder and pressing down.
STEP 3A: Align the Seat Bottom(A) with the Back(B)
noting where bolts will go through the frame, and into the
Back.
STEP 1: Place Cylinder(D) into Chair Base(C).
Any problems or questions call Regency Oce Furniture at 1-866-816-9822
Impresa Swivel Recliner & Ottoman • N1701 • INSTRUCTIONS
STEP 4A: Recline the Back(B) until the fasteners on the
Seat Bottom(A) and Back(B) overlap.
A
D
D
A
C
A
B
B
B
A
I
STEP 3B: Fasten the Back(B) with the Seat Bottom(A)
with two 3” Bolts(I), one per side, through the frame
and into the Back(B).
STEP 4B: Attach the Back(B) and Seat Bottom(A)
using both of the 1 3/16” Bolts(K) and both Nuts(M).
B
A
M
K
STEP 6: Attach Arms(E) to Seat Bottom(A) frame using
two 2” Bolts(J) per arm.
K
E
Front
STEP 5: Install the Knob & Washer(N) into the frame of
the Seat Bottom(A), allowing the seat to recline.
Any problems or questions call Regency Oce Furniture at 1-866-816-9822
STEP 7A: Attach the Ottoman Stem(H) to the under-
side of the Ottoman Top(G) using four 13/16” Bolts(L).
7B
A
H
G
L
N
A
E
J
J
J
NOTE: The front should be indicated on each Arm(E).
the incorrect arm will not work on the wrong side.
STEP 7B: Place the
Ottoman Stem(H) in to
the Ottoman Base(F)
by lining up the stem
with the hole and
pressing into place.
Impresa Swivel Recliner & Ottoman • N1701 • INSTRUCTIONS
/
