Regency 1015BK Installation guide

Any problems or questions call Regency Ofce Furniture at 1-866-816-9822

IMPORTANT NOTICE:

● Check to be sure that you have all parts and hardware.

● Remove all wrapping materials, including staples & packing straps before you start to assemble.

● Do not tighten all screws/bolts until completely assembled.

● Keep all hardware parts out of reach of children.

1015 - INSTRUCTIONS

Hardware:

G) Assembly Key ● H) Long Bolts(4) ● I) Washers(4) ● J) Short Bolts(4) ● K) Arm Washer

Parts:

A) Arms(2) ● B) Mechanism ● C) Casters(5) ● D) Base ● E) Cylinder ● F) Seat

Any problems or questions call Regency Ofce Furniture at 1-866-816-9822

STEP 1: Insert 5 Casters(C) into Base(D). STEP 2: Insert Cylinder(E) into Base(D).

C D

1015 - INSTRUCTIONS

STEP 3: Add 1 Washer(I) to each Short Bolt (J) and attach Mechanism(B) to Seat(F). Be sure that

the tilt tension knob is facing the front of the seat.

Note: Do NOT tighten Bolts until all bolts have been started.

STEP 4A: Lay seat on one side and place Arm Washer(K) over

each arm hole. Then attach arm to seat with 2 Long Bolts(H)

going through Arm(A), arm washer and nally into Seat(F).

STEP 4B: Repeat this step for second Arm(A).

STEP 5: Finish by placing Mechanism(B)

on Seat(F) into Cylinder(E) on Base and

apply force to the seat to ensure connection.