Page is loading ...
Any problems or questions call Regency Ofce Furniture at 1-866-816-9822
IMPORTANT NOTICE:
● Place all wooden parts on a clean and smooth surface such as a rug or carpet to avoid the parts from being scratched.
● Check to be sure that you have all parts and hardware.
● Remove all wrapping materials, including staples & packing straps before you start to assemble.
● Do not tighten all screws/bolts until completely assembled.
● Keep all hardware parts out of reach of children.
9975-9875-9875L • INSTRUCTIONS
Organize your parts and hardware. You will need a Phillips head screw driver.
Hardware :
A: 75mm bolts(4) • B: 60mm bolts(4) • C: 45mm bolts(1) • D: 40mm bolts(2) • E: Wood screws(3)
F: Locking washers(9) • G: Washers(9) • H: Wood caps(2) • I: Allen Key • J: Glue
B
C
D
Parts :
K: Leg/Arm(2) • L: Back Frame • M: Seat Frame • N: Seat Cushion
A
E
F
G
H
I
L
K
K
NOTE: EACH BOLT EXCEPT FOR 2 40MM BOLTS GETS 1 LOCK WASHER(F) FOLLOWED BY 1 FLAT WASHER(G).
J
N
M
Any problems or questions call Regency Ofce Furniture at 1-866-816-9822
STEP 4 : Using 2 40mm Bolts(D) attach the arms to
the back of the chair. Plug the holes with Caps(H) and
Glue(J).
9975-9875-9875L • INSTRUCTIONS
STEP 3 : Attach the Leg/Arm(K) to the Seat
Frame(M) using 4 75mm Bolts(A).
STEP 2 : Attach the Seat Frame(M) to the Back
Frame(L) using a 45mm Bolt(C) in the center and 2
60mm Bolts(B) on the left side then again on the right
side.
STEP 1 : Center the Seat Cushion(N) on the Seat
Frame(M) and attach using 3 Wood Screws(E).
N
M B C B
M
L
A
K
D
/
