Regency 3320BK Installation guide

Any problems or questions call Regency Ofce Furniture at 1-866-816-9822

IMPORTANT NOTICE:

● Check to be sure that you have all parts and hardware.

● Remove all wrapping materials, including staples & packing straps before you start to assemble.

● Do not tighten all screws/bolts until completely assembled.

● Keep all hardware parts out of reach of children.

3320 - INSTRUCTIONS

Hardware:

J) Assembly Key ● K) Long Bolts(8) ● L) Short Bolts(4) ● M) Caps(8)

Parts:

A) Seat ● B) Back ● C) Right Arm ● D) Left Arm ● E) Mechanism ● F) Sleeve ● G) Cylinder ● H) Base ● I) Casters(5)

L M

A B

C D

G H I

STEP 2: Insert Cylinder(G) into Base(H).

Any problems or questions call Regency Ofce Furniture at 1-866-816-9822

STEP 1: Insert 5 Casters(I) into Base(H).

STEP 3: Insert Sleeve(F) over Cylinder(G).

I H

STEP 4: Attach the Mechanism(E) to the Seat(A) using 4 Short Bolts(L). Be sure that the tilt tension knob is facing the front of the seat.

Note: Do NOT tighten bolts until all bolts have been started.

STEP 5: Attach Back(B) to Seat(A) by attaching Right Arm(C) with 4 Long

Bolts(K). Repeat this step for the Left Arm(D). Place Caps(M) over inserts.

Note: Do NOT tighten bolts on each arm until all bolts have been started.

STEP 6: Finish by placing Cylinder(G) into

Mechanism(E) and apply force to the seat to ensure

connection.

3320 - INSTRUCTIONS

Right Side Left Side

K K