Page is loading ...
1
Style A
© 2019 Midmark Corp. | 60 Vista Drive Versailles, OH 45380 USA | 1-800-643-6275 | 1-937-526-3662 |
Applies to Models:
VT
Special Tools:
Nutsert Tool - 002-0521-00
004-10225-00 Rev. AA1 (1/7/2020)
Wet or Dry Treatment Table Conversion Kit
Attention
New door and Nutsert Tool required for conversion, contact Midmark at 1-800-643-6275.
Note
Wet table conversion shown, follow same procedure for dry table.
midmark.com
English-2
© 2019 Midmark Corp. | 60 Vista Drive Versailles, OH 45380 USA | 1-800-643-6275 | 1-937-526-3662 |
Step 3:
Remove drawers from table by pulling drawers completely out, pull sides of drawer away
from glides and pull up and out.
Step 1:
Remove door from hinge plate by squeezing tab at back of hinge.
Step 4:
Mark drawer glide position before removing. Remove drawer glides from both sides of
inside of table. Remove screw (1) from front of each glide and pull glide forward from
back slot.
Step 2:
Remove hinge plates (2) from table by removing screws (4).
midmark.com
English-3
© 2019 Midmark Corp. | 60 Vista Drive Versailles, OH 45380 USA | 1-800-643-6275 | 1-937-526-3662 |
Step 7:
Install drawer glides into opposite side of table as shown in same position as marked.
Angle back of slide with tab when placing into slot in table frame. Rotate front of slide up
and secure with screw (1).
Step 5:
Remove back panel by removing screws (8) from inside table.
Step 8:
Install drawers by sliding drawer glides out and slide back of drawer under tabs in back of
slide. Push down on front of drawer to insert front tabs on slides in drawer slots.
Step 6:
Install back panel on opposite side of table secure with screws (8) from inside of table.
Equipment Alert
Midmark recommends 2 installers to
prevent damage to back panel.
Equipment Alert
Midmark recommends 2 installers
to install back panel.
midmark.com
/
